In the unstable patellofemoral joint (PFJ), the patella will articulate in an abnormal manner, producing an uneven distribution of forces. It is hypothesised that incongruency of the PFJ, even without clinical instability, may lead to degenerative changes. The aim of this study was to record the change in joint contact area of the PFJ after stabilisation surgery using an established and validated MRI mapping technique.

A prospective MRI imaging study of patients with a history of PFJ instability was performed. The patellofemoral joints were imaged with the use of an MRI scan during active movement from 0° through to 40° of flexion. The congruency through measurement of the contact surface area was mapped in 5-mm intervals on axial slices. Post-stabilisation surgery contact area was compared to the pre-surgery contact area.

In all, 26 patients were studied. The cohort included 12 male and 14 female patients with a mean age of 26 (15–43). The greatest mean differences in congruency between pre- and post-stabilised PFJs were observed at 0–10 degrees of flexion (0.54 cm² versus 1.18 cm², p = 0.04) and between 11° and 20° flexion (1.80 cm² versus 3.45 cm²; p = 0.01).

PFJ stabilisation procedures increase joint congruency. If a single axial series is to be obtained on MRI scan to compare the pre- and post-surgery joint congruity, the authors recommend 11° to 20° of tibiofemoral flexion as this was shown to have the greatest difference in contact surface area between pre- and post-operative congruency.

Abstract

Abstract

Rupture of the pectoralis major (PM) tendon is a rare yet severe injury. Several techniques have been described for PM fixation including a transosseus technique, when cortical buttons are placed at the superior, middle and inferior PM tendon insertion positions. The concern with this technique is the risk that bicortical drilling poses to the axillary nerve as it courses posteriorly to the humerus.

This cadaveric study investigates the proximity of the posterior branch of the axillary nerve to the drill positions for transosseus PM tendon repair. Drills were placed through the humerus at the superior, middle and inferior insertions of the PM tendon and the distance between these positions and the axillary nerve, which had previously been marked, was measured using computed tomography (CT) imaging.

This investigation demonstrates that the superior border of PM tendon insertion is the fixation position that poses the highest risk of damage to the axillary nerve.

Caution should be used when performing bicortical drilling during cortical button PM tendon repair, especially when drilling at the superior border of the PM insertion. We describe ‘safe’ and ‘danger’ zones for transosseus drilling of the humerus reflecting the risk posed to the axillary nerve.

The aim of this study is to document the outcome of a large cohort of patients treated with the Bereiter trochleoplasty with between 1 and 12 years of follow up.

215 consecutive cases in 186 patients were recorded prospectively. All patients were offered yearly clinical and radiological review. PROMs were recorded including the IKDC, OKS, Kujala and SF-12. Patients unable to attend clinic were assessed with PROMS and radiographs from their local institutions where possible.

There were 133 females and 53 males, with a mean age of 21 (14–38). There were no infections and only 6 patients reported further dislocations. There was one flap breakdown and no identified cases of secondary osteoarthritis. PROMs were available for 194 cases in 167 patients (90% follow up). 84% of patients were satisfied, 87% felt their symptoms had improved and 69% had gone back to sport. All scores improved (all p<0.001) except for the SF-12 mental score (p=0.42), with averages comparable to the results of MPFL reconstruction.

Good outcomes were observed despite the difficult patient population in which these cases were performed. The Bereiter trochleoplasty is an effective method of treating recurrent patella instability in patients with severe trochlea dysplasia.

The trapeziometacarpal joint (TMJ) is the most commonly involved arthritic joint in the hand and is often injected in the outpatient setting. This study assesses the accuracy of TMJ injections.

Six pairs of thawed, fresh-frozen cadaveric upper limbs were placed in the anatomic position. The limbs were randomized to be injected by one of two clinicians (a senior and a junior orthopaedic trainee). The TMJ of these specimens was palpated and injected with 0.5mls aqueous jelly dyed with methylene blue. An independent investigator dissected the specimens and the location of the dye was recorded. A Posterior-Anterior radiograph was then taken to assess the bony anatomy of the joint and graded according to Eaton's classification.

Dye was found inside the joint capsule in 10 (83%) of the 12 specimens. Using Fishers Exact test no significant difference was found between the 2 injectors (p=0.46). The 2 joints where the dye was extra-articular had grade III and IV arthritis, whereas all other joints were graded I.

This study shows that good accuracy of TMJ injection can be achieved using palpation in the earlier stages of TMJ arthritis, when surface anatomy is accurate enough for an intra-articular injection. This is also when synovitis is more prevalent and injections are more relevant. However the failure rate of injections increases as the disease advances.

Blockade of the suprascapular nerve (SSN) with local anaesthetic is used frequently in shoulder surgery and for chronic shoulder pain. Anatomical landmarks may be used to locate the nerve prior to infiltration with local anaesthetic, but ultrasound is becoming a popular to locate the nerve.

Twelve cadaveric shoulders from 6 specimens were injected with dye using the landmark and ultrasound technique. The shoulders were scanned with computed tomography, and then dissected to ascertain the accuracy of each technique.

Using CT scan results, we found the ultrasound group to be more accurate in placing the anaesthetic needle close to the suprascapular notch, and therefore nerve, and this was significant (p = 0.0009). When analysing the ink data, although we did not observe a significant difference in amount of nerve covered by ink, we did note a correlation, and, given this study group is small, that may be considered a statistical trend.

This study, which is one of the largest cadaveric studies investigating landmark and ultrasound guided block of the suprascapular nerve and we believe the first to use CT, demonstrates that ultrasound guided block is significantly more accurate than the landmark technique, and would therefore recommend that ultrasound guidance be used when blocking the suprascapular nerve, given its higher accuracy and lower complication rate.

Treatment of syndesmotic injuries is a subject of ongoing controversy. Locking plates have been shown to provide both angular and axial stability and therefore could potentially control both shear forces and resist widening of the syndesmosis. The aim of this study is to determine whether a two-hole locking plate has biomechanical advantages over conventional screw stabilisation of the syndesmosis in this pattern of injury. Six pairs of fresh-frozen human cadaver lower legs were prepared to simulate an unstable Maisonneuve fracture. The limbs were then mounted on a servo-hydraulic testing rig and axially loaded to a peak load of 800N for 12000 cycles. Each limb was compared with its pair; one receiving stabilisation of the syndesmosis with two 4.5mm quadricortical cortical screws, the other a two-hole locking plate with 3.2mm locking screws (Smith and Nephew). Each limb was then externally rotated until failure occurred. Failure was defined as fracture of bone or metalwork, syndesmotic widening or axial migration >2mm. Both constructs effectively stabilised the syndesmosis during the cyclical loading within 1mm of movement. However the locking plate group demonstrated superior resistance to torque compared to quadricortical screw fixation (40.6Nm vs 21.2Nm respectively, p value <0.03).

Introduction

The treatment of Neer type 2 lateral end clavicle fractures presents a difficult problem due to the high incidence of non-union, delayed union, shoulder girdle instability and the need for implant removal. We report our experience in 10 patients with acute fractures treated with a simple modified tension band suturing technique.