Advertisement for orthosearch.org.uk
Results 1 - 7 of 7
Results per page:
Applied filters
Content I can access

Include Proceedings
Dates
Year From

Year To
Orthopaedic Proceedings
Vol. 99-B, Issue SUPP_4 | Pages 54 - 54
1 Feb 2017
Kawano T Mori T
Full Access

Purpose

Degenerative osteoarthritis of the knee usually shows arthritic change in the medial tibiofemoral joint with severe varus deformity. In TKA, the medial release technique is often used for achieving mediolateral balancing, but there is some disagreement regarding the importance of pursuing the perfect rectangular gaps. Our hypothesis is that the minimal release especially in MCL is beneficial regarding on retaining the physiological medial stability and knee kinematics, which leads to improved functional outcome. Therefore, the purpose of this study is to examine the thickness of the tibia resection if the extent of the medial release is minimized to preserve the medial soft tissue in TKA.

Patients and Methods

Thirty TKAs were performed for varus osteoarthritis by a single surgeon. In the TKA, femoral bone was prepared according to the measured resection technique, bilateral meniscus and anterior cruciate ligament were excised. After the osteophytes surrounding the femoral posterior condyle were removed, the knee with the femoral trial component was fully extended and the amount of the tibial bone cut was decided for the 10mm tibial insert by referring to the medial joint line of the femoral trial component. After the every bone preparation and placement of all the trial components, If flexion contracture due to the narrow extension gap was found, additional tibial bone cut or medial soft tissue release were performed.


Orthopaedic Proceedings
Vol. 99-B, Issue SUPP_4 | Pages 55 - 55
1 Feb 2017
Kawano T Furusho H Mori T
Full Access

Introduction

The issue regarding whether suction drainage should be used during TKA continues to be debated as both methods have disadvantages. The use of a drain may increase estimated blood loss and incidence of blood transfusion, while no drainage may be associated with ecchymosis formation surrounding the surgical site and wound problems. This prospective randomized study aimed to clarify the need for suction drainage in TKA by assessing the short-term postoperative outcome.

Patients and Methods

We randomized 39 patients undergoing TKAs either with or without an intra-articular suction drain and divided to two groups. All the TKAs were performed by a single surgeon using cemented prostheses. As the perioperative blood management, air tourniquet was used during surgery, the knee arthrotomy was closed water-tightly, and all the patients were received both intra-articular and intra-venous administrations of tranexamic acid. After the surgery, a bulky compression dressing was applied to prevent the third space leakage of the blood for four days and rivaroxaban was used for venous thromboembolism prophylaxis for one week. The two groups were compared in terms of hemoglobin decrease, recovery of knee flexion, postoperative pain, and examined both the knee circumference and knee swelling. The incidence of short-term complications also evaluated.


Orthopaedic Proceedings
Vol. 99-B, Issue SUPP_2 | Pages 117 - 117
1 Jan 2017
Suzuki M Miyakoshi N Kasukawa Y Nozaka K Tsuchie H Fujii M Sato C Masutani N Kawano T Shimada Y
Full Access

The superior analgesic effects of minodronate compared with other bisphosphonates has been previously reported. However, to our knowledge, there are no studies analyzing the analgesic effects of bisphosphonates on chronic pain. The purpose of the present study was to evaluate the analgesic effects of minodronate (MIN), alendronate (ALN), and pregabalin (PRG) on chronic pain caused by chronic constriction injury (CCI) of the sciatic nerve.

Four-week-old female Wister rats underwent ovariectomy. At 8 weeks old, the left sciatic nerve was ligated to induce the chronic pain model (CCI side), and sham surgery was performed on the right posterior limb as a CCI control (control side). The rats were divided into the following four groups: 1) MIN group, administered with minodronate (0.15 mg/kg/week) (n = 10); 2) ALN group, administered with alendronate (0.15 mg/kg/week) (n = 10); 3) PRG group, administered with pregabalin (10 mg/kg) (n = 9); and 4) Control group, administered with vehicle (n = 10). Treatments were administered subcutaneously every week for 2 weeks immediately after CCI. To quantify the sensitivity to a tactile stimulus, paw withdrawal in response to a tactile stimulus was measured using von Frey filaments at 0, 1, and 2 weeks after CCI. Von Frey filaments were applied to the plantar surface of the hindpaws for 3 s, and this was repeated three times. Paw withdrawal in response to the stimulus was evaluated by scoring as follows: 0, no response; 1, a slow and/ or slight response to the stimulus; 2, a quick withdrawal response; 3, an intense withdrawal response away from the stimulus. The mean value of the score was adopted as the pain score. After evaluating the response, bilateral femurs were harvested for bone mineral density (BMD) measurements.

The pain score of the CCI side was significantly higher than that of the sham side in all groups (p < 0.05) at each time point. The pain score for the MIN group, but not the ALN group, of the CCI side was significantly lower (p = 0.05) at 0 and 1 week after CCI. Total femoral BMD of the CCI side was significantly lower in the PRG and Control groups than those of the MIN and ALN groups (p < 0.05). No significant difference was identified for BMD between the MIN and ALN groups.

Minodronate showed a significant analgesic effect on chronic pain and suppressed osteoporotic changes caused by CCI.


Orthopaedic Proceedings
Vol. 95-B, Issue SUPP_34 | Pages 463 - 463
1 Dec 2013
Ohmori Y Jingushi S Kawano T Itoman M
Full Access

Purpose:

In order to acquire good stability of an arthroplasty hip, the proper placement of the implants, which prevents impingement between the stem neck and the socket, is important. In general, the anteversion of the uncemented femoral stem depends on the relationship between the three-dimensional structure of the proximal femoral canal and the proximal stem geometry. The exact degree of the anteversion will be known just after broaching during the operation. If the stem anteversion could be forecasted, preoperative planning of the socket placement would be relatively easy. Furthermore, when a high degree of anteversion is forecasted, a special femoral stem to reduce it, such as a modular stem, could be prepared. However, we experienced that the preoperatively measured anteversion of the femoral neck using computer tomography (CT) was sometimes different from that of the stem measured during the operation. The purpose of this study was to investigate whether the preoperative measurement would be helpful to predict the stem anteversion by examining the relationship between the anteversion of the femoral neck and the stem.

Patients and methods:

A total of 57 primary THAs by one senior surgeon from April 2011 until March 2012 were carried out. Two THAs using a modular stem and one for the hip after previous proximal femoral osteotomy were excluded. The remaining 54 THAs were examined. The used uncemented stems were designed for proximal metaphyseal fixation. CT scans, including the distal femoral condyles as well as the hips, were carried out in all cases preoperatively. The anteversion of the femoral neck was measured as the angle of the maximum longitudinal line of the cross section of the femoral neck to the line connecting the posterior surfaces of both of the distal femoral condyles (Fig. 1). The femoral neck anteversion was measured at three levels (Fig. 1). The stem anteversion was measured just after the femoral broaching during the THA. The relationship between the anteversion angles of the femoral neck and of the stem was examined by using a regression analysis. The institutional review board approved this study.


Orthopaedic Proceedings
Vol. 95-B, Issue SUPP_34 | Pages 99 - 99
1 Dec 2013
Kawano T Ihara H Tsurusaki S
Full Access

[Introduction]

One of the modern design total knee arthroplasty (TKA) system, the NexGen Legacy posterior-stabilized (LPS) Flex prosthesis, has been in use at our hospital since 2001. Between 2006 and 2011, NexGen LPS-Flex primary TKA were mainly performed in combination with a cemented short-keeled minimally invasive version tibial tray (MIS tibial component) instead of the traditional NexGen stemmed tibial tray. We observed some cases required early revision of isolated tibial component in primary TKA performed in this period. Therefore, our objectives were to report the series of this revision cases and to consider this failure mechanism.

[Patients & Methods]

A total of 526 primary TKAs were performed using a NexGen LPS-Flex prosthesis and MIS tibial component during five-year period at our hospital. The mean age was 74 years at the time of the index procedure. We assessed revision rate of this tibial tray in this study and described clinical course of the revision cases. We also examined the clinical and radiographic features which could be associated with the failure.


Orthopaedic Proceedings
Vol. 86-B, Issue SUPP_IV | Pages 401 - 401
1 Apr 2004
Miura H Higaki H Kawano T Nakanishi Y Matsuda S Iwamoto Y
Full Access

Flexion after total knee arthroplasty (TKA) has recently been improved by changing implant designs, surgical techniques and early postoperative rehabilitation protocols. Especially for Asian people, deep knee flexion is essential because of their life style. Small numbers of patients can achieve full flexion after TKA, however, most current prostheses are not designed to allow deep knee flexion safely. Furthermore, the kinematics involved in knee flexion greater than 90 degrees in cases of TKA is still unknown, even though fluoroscopic studies have shown the paradoxical anterior femoral translation in posterior cruciate retaining (CR) TKA with knee flexion up to 90 degrees. The purpose of this study was to determine the femoro-tibial contact pattern in deep knee flexion.

The knee that had been operated upon was passively flexed from 90 degrees up to the maximum flexion under anesthesia soon after the surgery. Lateral roentgenograms of the knee were taken during flexion, and the three-dimensional kinematics was analyzed using image-matching techniques. Nine patients with CR type were included.

The average maximum flexion angle was 131.8 °. The contact point moved posteriorly with deep knee flexion except for one patient. Five out of nine patients showed external rotation of the femoral condyle. Two patients showed internal rotation, and the other two exhibited no rotational movement. None of the patients showed dislocation or disengagement of the components. At the maximum flexion, the edge of the posterior flange of the femoral component contacted the polyethylene insert.

This study was performed under non-weight-bearing conditions, but deep knee flexion is not usually performed in weight-bearing conditions. Most of the CR type showed posterior roll back during deep knee flexion. The design of the posterior flange of the femoral component should be changed to prevent damage to the polyethylene.


Orthopaedic Proceedings
Vol. 86-B, Issue SUPP_IV | Pages 419 - 419
1 Apr 2004
Kawano T Miura H Mawatari T Morooka T Higaki H Matsuda S Iwamoto Y
Full Access

Introduction: Analyses of the 3-D kinematics of TKA in vivo using the x-ray image matching techniques have been widely reported. However, the accuracy of those techniques has seemed not to be discussed enough. To demonstrate more accurate technique for those analyses, we developed the new calibration flame to detect the geometry of the x-ray source and more accurate image matching methods.

Materials and methods: A calibration flame was composed of four ball bearing markers. First, the optimal distributions of those ball markers were determined by computer simulations, and then, using the high-resolutional computed radiography (CR) of a metallic ball taken with the obtained optimal calibration flame, the resolving power of three degrees of freedom (DOF) translations were calculated. Next, the computer-synthesized projected images of the femoral component of TKA were calculated using the estimated x-ray source geometry and experimentally measured geometric data of the prosthesis when the full six DOF poses of the prosthesis were calculated. Matching the computer-synthesized images with the extracted and binalized 2-D CR images of the prosthesis was done automatically using computer in order to minimize the exclusive OR (XOR).

Results: The geometry of the x-ray source was estimated with accuracy of below 0.5 mm in computer simulations. The CR images of the prosthesis were matched with the computer-synthesized images until the XOR reached under one pixel and then, the accuracy of below 1.0 mm translations and 1.0 degrees rotation were recognized for the resolving power of six DOF poses of the prosthesis.

Discussion: The more accurate measurement of full six DOF poses is indispensable to estimate not only the 3-D kinematics but also the contact stresses or predicted polyethylene wear on TKA in vivo. The new calibration flame and the image matching technique we developed appear to be effective for analyses of TKA in vivo.