Abstract
Proper restoration of posterior condylar offset during TKA has been shown to be important to maximize range of motion and minimize flexion instability. However, there is little information as to the importance of restoration of mid-sagittal femoral geometry. There is controversy as to whether a TKA prosthesis should have a single radius or multiple radii of curvature. The purpose of this study is to evaluate the effectiveness of a multi-radius femoral component at restoring mid sagittal femoral offset.
A consecutive series of 100 TKAs with digital preoperative and postoperative radiographs and standardized radiographic markers were analyzed. There were 71 female and 29 male knees with mean age of 59 years. All TKAs were performed by a single surgeon using a multi-radius femoral component design. The distal femoral resection was set to resect 10 mm from the distal femoral condyle and a posterior referencing system was used to size the femoral component. Using radiographic perfect lateral projections of the knees, a line was drawn along the posterior femoral shaft and another parallel line down the anterior femoral shaft. A 3rd line was then drawn parallel to the posterior shaft at the furthest point posterior on the condyle. A 4th line was drawn parallel to the anterior shaft at the furthest point anterior on the femur. 90 degree angles were constructed to create a grid in the anterior and posterior directions, similar to a previously reported technique. Finally, 45 degree angle lines were created in the grid to assess mid flexion dimensions [Fig-1 and 2]. The percent change in posterior condylar offset (PCO), anterior femoral offset (AFO), mid femoral anterior offset (MAFO) and mid femoral posterior offset (MFPO) were calculated.
The mean reproduction of the mid-anterior femoral offset and mid-posterior femoral offset were 101.1% [range 56.5%–167.5%] and 96.8% [range 54.9%–149.0%] of preoperative measurements respectively. The average restoration of posterior offset and anterior offset were 92.8% [range 49.0%–129.8%] and 115.3% of preoperative measurements [range 35.7%–400.0%] respectively. When the posterior condylar offset was restored to within 10% of the native anatomy, the MPFO restoration more closely resembled normal anatomy (103.0% vs. 93.9%, p = 0.005). When the postoperative posterior condylar offset was decreased greater than 20%, both the MAFO (90.1% vs. 104.5%, p = 0.004) and MPFO (78.5% vs. 102.9%, p < 0.001) decreased compared to the native knee. There was no relationship between restoration of the PCO and the MAFO correction (104.6% vs. 99.4%, p = 0.213). Finally, there was no correlation between restoration of anterior femoral offset within 10% of normal and the restoration of mid sagittal femoral offset; 98.0% vs 102.0% for MAFO (p = 0.320) and 98.7% vs 96.3% for MPFO (p = 0.569).
A modern multi-radius condylar knee design is capable of reproducing the mid-sagittal geometry of the preoperative knee. However, the restoration of mid sagittal offset is largely dependent on the restoration of the posterior condylar offset. Intraoperative adjustments in anterior and posterior femoral resections can have significant impact in the ability of the implant to reproduce mid-sagittal femoral anatomy.
