Abstract
Introduction: The concept that aseptic loosening is a function of polyethylene wear has led to the use of cross-linked polyethylene in total hip arthroplasty (THA). We studied the relationship between polyethylene wear rate and aseptic loosening in order to model the potential effects of wear-reducing strategies on the failure rate for each prosthetic component.
Methods: 350 subjects who had previously undergone Charnley THA were divided into 3 groups: Controls (n=273); those with loosening of only the femoral stem (n=43); and those with only cup loosening (n=34). Poly-ethylene wear was measured using a validated method (EBRA). The relationship between wear rate and loosening was examined using logistic regression analysis, and estimates of the effect of wear rate modulation made using odds-ratios.
Results: The median annual wear rate in the controls (0.07mm) was lower than both stem looseners (0.09mm, p=0.002) and cup looseners (0.18mm, p< 0.001). The odds of cup loosening increased 4.7 times per standard deviation (SD) increase in wear rate above the reference (control) population (p< 0.001). The odds of stem loosening increased 1.7 times per SD, but was not independent of other risk factors (p> 0.05). The potential reduction in risk of loosening was calculated using the following formula: (OR^SD2)/(OR^SD1), where 1 and 2 are the new and old mean z-score wear rates. Thus, for a 25% or 50% reduction in wear rate, the incidence of cup loosening may reduce by 71% and 293%, respectively. The rate of stem loosening may, at best, reduce by 7% and 17%, respectively.
Discussion: Wear reduction strategies, such as cross-linked polyethylene, have the potential for a major impact on the incidence of cemented cup, but not stem, loosening.
Correspondence should be addressed to Mr Carlos Wigderowitz, Senior Lecturer, University Department of Orthopaedic and Trauma Surgery, Ninewells Hospital and Medical School, Dundee DD1 9SY.
