Abstract
Introduction & Aims: A new femoral component for hip arthroplasty has been designed for a younger patient population. The design makes use of a higher femoral cut, which conserves bone stock, increasing options for future revision surgery. It uses the existing load bearing properties of the proximal femur, and therefore distributes load more evenly. The stem is longer than that of a resurfacing, so will be easier to insert at the correct orientation, minimising failure rates in inexperienced hands. The cross-sectional dimensions have been designed to produce torsional stability. The collar maximises the loading of the calcar, reducing stress resorption. The surface is hydroxyapatite coated and porous, which will produce a long-term biological fixation.
This project assessed the long-term stability of this design at different orientations, by measuring the change in surface strain distribution following its insertion.
Methods: Ten composite bones were coated in a Photoelastic material, positioned at a simplified single leg stance, and loaded at 2.3 KN. The surface strain was measured at one-centimetre intervals down the medial cortex. Then the prostheses were inserted into the bone at 135°, 145° and 125° to the femoral shaft, and the surface strains reread.
Results: The results were compared with an FEA model, and analysed statistically using the Wilcox signed rank test. The prosthesis inserted at 135° produced no significant difference in surface strain distribution compared with the intact bone.
Conclusions: This study suggests this stem design will be stable in the long term following insertion, and there were no areas of excessively high or low strain.
Correspondence should be addressed to The Secretary, BHS, c/o BOA, The Royal College of Surgeons, 35–43 Lincoln’s Inn Fields, London WC2A 3PE.
