Abstract
A secure bone/cement interface at the bone cement junction is an important requirement for the long-term success in the cemented hip arthroplasty. Cementing techniques have evolved and now involve pressurisation of the acetabulum and femur. It can be difficult to get a complete rim seal and hence adequate pressurisation due to the unique anatomy of the acetabulum and the contyloid notch.
Several acetabular pressurisers are commercially available.
We have developed an instrument for controlled and reproducible cement pressurisation in the acetabulum before socket insertion. It is a T-bar incorporating a central plunger, which protrudes from an outer sleeve when force is applied. The protrusion of the central plunger and hence the amount of force applied can be limited by a stop-sleeve.
A laboratory saw bone model was designed to assess this system and compare it with two existing pressurisers. A polypropylene model of the acetabulum was used. Included in the model were two 1.3mm diameter capillary outlets, one at its pole and one at a point close to its rim opposite the cotyloid notch. Water was free to flow through the capillaries at a pressure of 13.5” WG to represent blood flow. 5 test per pressuriser were performed.
CMW 1 Gentamicin bone cement was mixed as per manufacturers instruction in a Vacuum Mix system. The cement was then pressurised using one of three systems; the Depuy T handle pressuriser, the Exeter pressuriser and our new instrument.
The cement mantle produced with the Depuy T-handle and the Exeter pressuriser was thicker at the pole than the rim and the cement intrusion was not consistent nor reproducible. The new pressurizer produced a cement mantle equal at the pole and the rim to within 1mm. A reproducible cement mantle compatible to the shape of the socket and with cement intrusion of 5mm (+/− 1mm) could be achieved. We recommend the use of this pressuriser.
Theses abstracts were prepared by Mr Peter Kay. Correspondence should be address to him at The Hip Centre, Wrightington Hospital, Appley Bridge, Wigan, Lancashire WN6 9EP.
