For preoperative planning of Total Hip Arthroplasty (THA) it is paramount to choose the correct implant size to avoid subsidence with too small a component or fracture with too large a component. This planning can be done either in 2D or 3D. 2D templating from X-rays frontal images remains the gold standard technique in THA preoperative planning despite the lower accuracy with uncemented components. 3D planning techniques require a CT-Scan examination overexposing patients to radiation. Biplanar EOS® radiographs are an alternative to obtain bone 3D reconstructions with a very low dose of radiation. The objective of this study was to evaluate the accuracy and reproducibility a novel 3D technique for THA preoperative planning based on biplanar low-dose radiographs. 31 patients (20 women, 11 men, average age 66.1 y/o) who underwent a primary THA (Hardinge anterolateral approach) were included. Two senior orthopedic surgeons (Op_1 and Op_2) performed the pre-operative planning: (1) In 2D superimposing templates of the cup and the stem on CR radiographs. The CR images had a magnification coefficient of 1.15. (2) In 3D using dedicated hipEOS (EOS Imaging, France) software. 2D planning was performed once by each operator, 3D planning twice. 3D planning with hipEOS [Figure 1] was performed by importing 3D models of the stem and cup and superimposing them on frontal-lateral EOS® radiographs. This software proposes an initial estimate of the components size and position. If necessary, the user can correct the size of the stem and perform translations and rotations of the 3D models in order to correct the position, while clinical parameters such as the cup anteversion and inclination, as well as the femoral offset and leg length are automatically recalculated. To evaluate the accuracy, we have compared the 2D and 3D planning with respect to the actual size implanted during the surgery. To evaluate reproducibility we have calculated the Intra-class Correlation Coefficient (ICC) of both techniques.Introduction
Materials and methods
Navigation technology is a new tool which can help surgeons to a more accurate hip component implantation and a better reproducibility of the procedure. The purpose of this study was to compare conventional and navigated technique and a new developed straight hip stem for uncemented primary total hip replacement. The results of two consecutive implantation series of 42 patients (non navigated) and 42 patients (navigated) were analysed for implant positioning and short term complications. Non navigated components were implanted through conventional incision (15 cm), navigated component by minimal invasive surgery (5 cm). All surgeries were performed through Hardinge approach and by a single senior surgeon. Radiographic analysis of cup position showed a significant improvement with reduced radiological inclination (53° non navigated/44° navigated, p<
0.001) and higher anteversion (7° non navigated/12° navigated, p<
0.001). The mean postoperative limb length difference was 6.2 mm (SD 9.0, non navigated) and 4.4 mm (SD 6.4, navigated). Intraoperative and early postoperative complications were not different. No dislocation occurred in both groups. There was one intraoperative trochanter fracture which was not revised (non navigated) and one revision because of a periprosthetic fracture caused by fall down during rehabilitation (navigated). We conclude that acetabular implant positioning can be significantly improved by the use of navigated surgery technique even in minimal invasive surgery condition. The data for postoperative limb length difference was still similar but within the expected range in both groups. Navigation technology seems essential for minimal invasive surgical procedure yielding help and security to the surgeon. The effect of improved cup positioning on mid and long term results for both groups have to be further investigated.
Hallus valgus was corrected whenever present: in three cases an osteotomy was performed alone to raise the first metatarsal followed by a plantar prosthesis. A basal osteotomy of the three middle metatarsals was performed to achieve elevation, valgisation, and shortening: for three cases a Weil osteotomy was performed.