The external fixator is an invaluable device when treating acute complex trauma and in limb reconstruction. It is therefore important to ensure its efficient and safe application to avoid complications. A lot of research has been done to evaluate the factors around external fixator stability, pin site infections and more is still being done to understand pin loosening. The purpose of this study was to evaluate other factors that may contribute in external fixator pin loosening. The aim was to evaluate if the different Schanz pin insertion techniques contribute to pin loosening. Two tibia diaphyses from two cadavers were each divided into three sections. Three different drilling techniques were repeated in each of the sections. A total of 36 Schanz pins were inserted and a section cut out of the bone in front of the pins was done allowing visual inspection of the pin hole for features of thread stripping. These features were predefined as thread pattern disruption, smoothening and shallow imprint on the cortex. Evidence of pin thread stripping was seen in all of the pin insertion techniques. The first method where the hole was pre-drilled and pin inserted with the drill showed 100% thread stripping. The second method of pre-drilling and hand insertion showed the least amount with 16.7% of pin stripping noted and 66.7% pin thread stripping was observed when inserting the pin with power without pre-drilling the pilot hole using the third method. Different pin insertion techniques result in varying amounts of pin thread stripping. The most amount of thread stripping occurs when a Schanz pin is inserted with power after pre-drilling. This finding, although not measured scientifically, supports the current recommendation of pre-drilling and manual insertion of the pin. In future, more scientific measurement are necessary to quantify these findings and assess their clinical significance.
Using digital X-rays to plan a hip replacement can cause problems with sizing and templating the prosthesis. Using an AP view of both hips is desirable as this allows the use of the sometimes unaffected contralateral hip for templating. We devised a method of using a 20mm ball bearing as a marker positioned at the same depth as the greater trochanter, but between the patient's legs. Placing the marker between the patient's legs avoids the problem of the marker disappearing off the side of the X-ray, as is seen when placing the marker at the side of the obese patient. The marker is then used to calibrate the size of the digital X-ray. We used a hundred consecutive post-operative X-rays, comparing the size of the head of the femoral prosthesis used at surgery with the size measured pre-operatively using the marker.Background
Method
