Aims. Iliopsoas impingement occurs in 4% to 30% of patients after undergoing total hip arthroplasty (THA). Despite a relatively high incidence, there are few attempts at modelling impingement between the iliopsoas and acetabular component, and no attempts at modelling this in a representative cohort of subjects. The purpose of this study was to develop a novel computational model for quantifying the impingement between the iliopsoas and acetabular component and validate its utility in a case-controlled investigation. Methods. This was a retrospective cohort study of patients who underwent THA surgery that included 23 symptomatic patients diagnosed with iliopsoas tendonitis, and 23 patients not diagnosed with iliopsoas tendonitis. All patients received postoperative CT imaging, postoperative standing radiography, and had minimum six months’ follow-up. 3D models of each patient’s prosthetic and bony anatomy were generated, landmarked, and simulated in a novel iliopsoas impingement detection model in supine and standing pelvic positions. Logistic regression models were implemented to determine if the probability of pain could be significantly predicted. Receiver operating characteristic curves were generated to determine the model’s sensitivity, specificity, and area under the curve (AUC). Results. Highly significant differences between the symptomatic and asymptomatic cohorts were observed for iliopsoas impingement. Logistic regression models determined that the impingement values significantly predicted the probability of groin pain. The simulation had a sensitivity of 74%, specificity of 100%, and an AUC of 0.86. Conclusion. We developed a computational model that can quantify iliopsoas impingement and verified its accuracy in a case-controlled investigation. This tool has the potential to be used preoperatively, to guide decisions about optimal cup placement, and postoperatively, to assist in the diagnosis of iliopsoas tendonitis. Cite this article: Bone Jt Open 2023;4(1):3–12

Acetabular component positioning is commonly referenced with the pelvis in the supine position in direct anterior approach THA. Changes in pelvic tilt (PT) from the pre-operative supine to the post-operative standing positions have not been well investigated and may have relevance to optimal acetabular component targeting for reduced risk of impingement and instability. The aims of this study were therefore to determine the change in PT that occurs from pre-operative supine to post-operative standing, and whether any factors are associated with significant changes in tilt ≥13° in posterior direction. 13° in a posterior direction was chosen as that amount of posterior rotation creates an increase in functional anteversion of the acetabular component of 10°. 1097 THA patients with pre-operative supine CT and standing lateral radiographic imaging and 1 year post-operative standing lateral radiographs (interquartile range 12–13 months) were reviewed. Pre-operative supine PT was measured from CT as the angle between the anterior pelvic plane (APP) and the horizontal plane of the CT device. Standing PT was measured on standing lateral x-rays as the angle between the APP and the vertical line. Patients with ≥13° change from supine pre-op to standing post-op (corresponding to a 10° change in cup anteversion) were grouped and compared to those with a <13° change using unpaired student's t-tests. Mean pre-operative supine PT (3.8±6.0°) was significantly different from mean post-operative standing PT (−3.5±7.1°, p<0.001), ie mean change of −7.3±4.6°. 10.4% (114/1097) of patients had posterior PT changes ≥13° supine pre-op to standing post-op. A significant number of patients, ie 1 in 10, undergo a clinically significant change in PT and functional anteversion from supine pre-op to standing post-op. Surgeons should be aware of these changes when planning component placement in THA

Introduction. Patients with reduced lumbar spine mobility are at higher risk of dislocation after THA as their hips have to compensate for spinal stiffness. Therefore our study aimed to 1) Define the optimal protocol for identifying patients with mobile hips and stiff lumbar spines and 2) Determine clinical and standing radiographic parameters predicting high hip and reduced lumbar spine mobility. Methods. This prospective diagnostic cohort study followed 113 consecutive patients with end-stage hip osteoarthritis (OA) awaiting THA. Radiographic measurements were performed for the lumbar lordosis angle, pelvic tilt and pelvic-femoral angle on lateral radiographs in the standing, ‘relaxed-seated’ and ‘deep-seated’ (i.e. torso maximally leaning forward) position. A “hip user index” was calculated in order to quantify the contribution of the hip joint to the overall sagittal movement performed by the femur, pelvis and lumbar spine. Results. Radiographs in the relaxed-seated position had an accuracy of 56% (95%CI:46–65%) to detect patients with stiff lumbar spines, compared to a detected rate of 100% in the deep-seated position. The mean ‘hip user index’ was 63±12% and ten patients (9%) were hip users, having an index of 80% or more. A standing pelvic tilt of ≥18.5° was the only predictor for being a hip user with a sensitivity of 90% and specificity of 71% (AUC 0.83). Patients with a standing pelvic tilt ≥18.5° and an unbalanced spine with a flatback deformity had a 30xfold relative risk (95%-CI:4–226; p<0.001) of being a hip user. Conclusion. Patients awaiting THA and having high hip and reduced lumbar spine mobility can be screened for with lateral standing radiographs of the spinopelvic complex and a thorough clinical examination. If the initial screening is positive, radiographs in the deep-seated position allow for better identification of patients being ‘hip users’ compared to radiographs in the relaxed-seated position