Introduction. The degree of
Previous study reported that intra-articular injection of MgSO4 could alleviate pain related behaviors in a collagenase induced OA model in rats. It provided us a good description on the potential of Mg2+ in OA treatment. However, the specific efficiency of Mg2+ on OA needs to be further explored and confirmed. The underlying mechanisms should be elucidated as well. Increasing attention has been paid on existence of synovial fluid MSCs (SF-MSCs) (not culture expanded) which may participate in endogenous reparative capabilities of the joint. On the other hand, previous studies demonstrated that Mg2+ not only promoted the expression of integrins but also enhanced the strength of fibronectin-integrin bonds that indicated the promotive effect of Mg2+ on cell adhesion, moreover, Mg2+ was proved could enhance chondrogenic differentiation of synovial membrane derived MSCs by modulating integrins. Based on these evidence, we hypothesize herein intra-articular injection of Mg2+ can attenuate
Introduction. Oriental people habitually adopt formal sitting and squatting postures, the extreme flexion of the knees allowing of this. The influence exercised by pressure and posture are, therefore, found at the posterior side of knee joint. However, we don't have many report about articular cartilage of posterior femoral condyle. Objectives. The purpose of this study was to reveal the accurate prevalence and related factors to the presence of degenerative changing of the articular cartilage of posterior femoral condyle in cadaveric knee joints. Methods. One hundred and thirty two knees from 66 cadavers (42 male knees and 24 female knees, formalin fixed, Japanese anatomical specimens) were included in this study. The average age of the cadavers was 81.4 (56–101) years. Knees were macroscopically evaluated the depth of
Osteoarthritis (OA) is a chronic degenerative joint disease with
Adolescent idiopathic scoliosis (AIS) is a poorly understood progressive curvature of the spine. The 3-dimmensionnal spinal deformation brings abnormal biomechanical stresses on the load-bearing organs. We have recently reported for the first time the presence of facet joint
Introduction:. Unicompartmental knee arthroplasty (UKA) has been used in the past decades to treat progressive
Osteoarthritis (OA) is a multifactorial debilitating disease that affects over four million Canadians. Although the mechanism(s) of OA onset is unclear, the biological outcome is cartilage degradation. Cartilage degradation is typified by the progressive loss of extracellular matrix components - aggrecan and type II collagen (Col II) – partly due to the up-regulation of catabolic enzymes - aggrecanases a disintegrin and metalloprotease with thrombospondin motifs (ADAMTS-) 4 and 5 and matrix metalloproteinases (MMPs). There is currently no treatment that will prevent or repair joint damage, and current medications are aimed mostly at pain management. When pain becomes unmanageable arthroplastic surgery is often performed. Interest has developed over the presence of calcium crystals in the synovial fluid of OA patients, as they have been shown to activate synovial fibroblasts inducing the expression of catabolic agents. We recently discovered elevated levels of free calcium in the synovial fluid of OA patients and raised the question on its role in
The lifetime prevalence of symptomatic osteoarthritis at the knee is 50% osteoarthritis of the ankle occurs in only 1% of the population. This variation in prevalence has been hypothesised to result from the differential responsiveness of the joint cartilages to catabolic stimuli. Human cartilage explants were taken from the talar domes (n=12) and the femoral condyles (n=7) following surgical amputation. Explants were cultured in the presence of either a combination of high concentration cytokines (TNFα, OSM, IL-1α) to resemble a post traumatic environment or low concentration cytokines to resemble a chronic osteoarthritic joint. Cartilage breakdown was measured by the percentage loss of Sulphated glycosaminoglycan (sGAG) from the explant to the media during culture. Expression levels of the pro-inflammatory molecules nitric oxide and prostaglandin E. 2. were also measured. Significantly more sGAG was lost from knee cartilage exposed to TNFα (22.2% vs 13.2%, P=0.01) and TNFα in combination with IL-1α (27.5% vs 16.0%, P=0.02) compared to the ankle; low cytokine concentrations did not affect sGAG release. Significantly more PGE. 2. was produced by knee cartilage compared to ankle cartilage however no significant difference in nitrite production was noted. Cartilage from the knee and ankle has a divergent response to stimulation by pro-inflammatory cytokines, with high concentrations of TNFα alone, or in combination with IL-1α amplifying
Statement of Purpose. Meniscal tears are common knee injuries that subsequently lead to degenerative arthritis, attributed to changes in stress distribution in the knee. In such cases there is need to protect the articular cartilage by repairing or replacing the menisci. While traditionally, meniscal replacement involves implantation of allografts, problems related to availability, size matching, cost and risk of disease transmission limit their use. Another optional treatment is that of biodegradable scaffolds which are based principally on tissue engineering concepts. The variability in body response to biodegradable implants and the quality of the tissue formed still pose a problem in this respect, under intense knee loading conditions. Moreover, biological solutions are mostly limited to younger patients <40 years old. Therefore, the goal of this study was, to develop a synthetic meniscal implant which can replace the injured meniscus, restore its function, and relieve pain. Methods. A composite, non-fixed self-centering discoid-shaped meniscus implant (NUsurafce®, AIC, Memphis, TN), composed of polycarbonate-urethane (PCU) and reinforced circumferentially with UHMWPE fibers is proposed (Fig. 1). The implant geometry was based on an extensive MRI study of over 100 knee scans [1]. The proposed structure aims to mimic the circumferential collagen reinforcement of the natural meniscus. Biomechanical evaluation of the implant was focused on in-vitro measurements of contact pressure under the implant in cadaver knees and computational finite element (FE) analyses [2,3]. Pressure distribution on the tibial plateau (under the meniscus implant) was measured by pressure sensitive films (Tekscan, MA) and quantified with respect to the natural meniscus. FE analyses were used to evaluate internal stress and strains, and to support the selection of optimal implant configuration. The last pre-clinical step was a large-animal (sheep) study in which the cartilage condition was evaluated microscopically over six months [4]. Results. Contact pressure distributions on the tibia, were in good agreement with those measured under the natural meniscus (Fig. 2). Specifically, peak and average pressures developed under the implant were found to similar to those of the natural meniscus. The contact area measured under the implant (658±135mm. 2. ) was also restored when compared to the natural meniscus (642±96mm. 2. ). FE models confirmed that internal strains/stresses within the device components remained within the materials' allowed limits. The evaluation of an implant adapted to sheep showed no signs of wear or degradation of the materials. Histology showed relatively mild
Introduction. There is interest in minimally invasive solutions that reduce osteoarthritic symptoms and restore joint mobility in the early stages of
Introduction. Geometric variations of the hip joint can give rise to abnormal joint loading causing increased stress on the articular cartilage, which may ultimately lead to degenerative joint disease. In-vitro simulations of total hip replacements (THRs) have been widely reported in the literature, however, investigations exploring the tribology of two contacting cartilage surfaces, and cartilage against metal surfaces using complete hip joint models are less well reported. The aim of this study was to develop an in-vitro simulation system for investigating and comparing the tribology of complete natural hip joints and hemiarthroplasties with THR tribology. The simulation system was used to assess natural porcine hip joints and porcine hemiarthroplasty hip joints. Mean friction factor was used as the primary outcome measure to make between-group comparisons, and comparisons with previously published tribological studies. Method. In-vitro simulations were conducted on harvested porcine tissue. A method was developed enabling natural acetabula to be orientated with varying angles of version and inclination, and natural femoral heads to be potted centrally with different orientations in all three planes. Acetabula were potted with 45° of inclination and in the complete joint studies, natural femoral heads were anatomically matched and aligned (n=5). Hemiarthroplasty studies (n=5) were conducted using cobalt chrome (CoCr) heads mounted on a spigot (Figure 1), size-matched to the natural head. Natural tissue was fixed using PMMA (polymethyl methacrylate) bone cement. A pendulum friction simulator (Simulator Solutions, UK), with a dynamic loading regime of 25–800N, ± 15° flexion-extension (FE) at 1 Hertz was used. The lubricant was a 25% (v/v) bovine serum. Axial loading and motion was applied through the femoral head and frictional torque was measured using a piezoelectric transducer, from which the friction factor was calculated. Results. The correct anatomical orientation and positioning was achieved enabling in-vitro simulation testing to be conducted on hemiarthroplasty and complete hip joint samples for two-hours. Mean friction increased rapidly followed by a continued gradual increase to ≈0.03 ± 0.00 in the complete joints, with the hemiarthroplasty group plateauing at ≈0.05 ± 0.01 (Figure 2). Mean friction factor was significantly lower (t-test; p < 0.05) in the complete natural joint group. Discussion. An in-vitro simulation system for the natural hip joint with controlled orientation of the femur and acetabulum was successfully developed and used to measure friction in complete porcine hip joints and porcine hip hemiarthroplasties. A non-linear increase in friction indicative of biphasic lubrication was observed in both groups with slower exudation of fluid from the complete joints compared to the hemiarthroplasties, inferring a quicker move towards solid-phase lubrication. Higher friction in the hemiarthroplasties, which was similar to that measured in-vitro in metal-on-polyethylene THRs, was most likely due to variable clearances between the non-conforming spherical metal head and aspherical acetabulum, causing poorer congruity and distribution of the load. This could in time lead to abrasive wear and cartilage degradation. This methodology could have an important role when investigating associations between hip geometric variations, interventions for hip disease/pathology, and risk factors for
Background. As hallux valgus (HV) worsens clinical and radiological signs of arthritis develop in metatarsophalangeal joint due to incongruity of joint surfaces. The purpose of this prospective study was to determine if intraoperative mapping of articular erosion of the first metatarsal head, base of the proximal phalanx, and tibial and fibular sesamoids can be correlated to clinical and/or radiographic parameters used during the preoperative assessment of the HV deformity. Materials and methods. We analysed 50 patients prospectively who underwent surgery between Jan 2009-Jan 2010. Patients with a known history of previous first metatarsophalangeal joint surgical intervention, trauma, or systemic arthritis were excluded from analysis. Preoperative demographics and AOFAS score were recorded. Intraoperative evaluation and quantification of the first metatarsal head, base of the proximal phalanx, and sesamoid articular cartilage erosion was performed. Cartilage wear was documented using International Cartilage Research Society grading. Results and Discussion. P. Bock et al have showed that the extent of cartilage lesions were clearly correlated with the degree of hallux valgus angle proving that a malaligned joint is more prone to
Introduction. The low-cost, no-harm conditions associated with vibroarthography, the study of listening to the vibrations and sound patterns of interaction at the human joints, has made this method a promising tool for diagnosing joint pathologies. This current study focuses on the knee joint and aims to synchronize computational models with vibroarthographic signals via a comprehensive graphical user interface (GUI) to find correlations between kinematics, vibration signals, and joint pathologies. This GUI is the first of its kind to synchronize computational models with vibroarthographic signals and gives researchers a new advantage of analyzing kinematics, vibration signals, and pathologies simultaneously in an easy-to-use software environment. Methods. The GUI (Figure 1) has the option to view live or previously captured fluoroscopic videos, the corresponding computational model, and/or the pre- or post-processed vibration signals. Having more than one signal axes available allows for comparison of different filtering techniques to the same signal, or comparison of signals coming from different sensor placements (ex: medial vs. lateral femoral condyle). Using computational models derived using fluoroscopic data synchronized with the vibration signals, the areas of contact between articulating surfaces can be mapped for the in vivo signal (figure 2). This new method gives the opportunity to find correlations between the different sensor signals and contact maps with the diagnosis and
Treatment for osteoarthritis (OA) has traditionally
focused on joint replacement for end-stage disease. An increasing number
of surgical and pharmaceutical strategies for disease prevention
have now been proposed. However, these require the ability to identify
OA at a stage when it is potentially reversible, and detect small
changes in cartilage structure and function to enable treatment
efficacy to be evaluated within an acceptable timeframe. This has
not been possible using conventional imaging techniques but recent
advances in musculoskeletal imaging have been significant. In this
review we discuss the role of different imaging modalities in the
diagnosis of the earliest changes of OA. The increasing number of
MRI sequences that are able to non-invasively detect biochemical
changes in cartilage that precede structural damage may offer a
great advance in the diagnosis and treatment of this debilitating
condition. Cite this article: