There is still want of evidence in the current literature of any significant improvement in clinical outcome when comparing computer-assisted total knee arthroplasty (CA-TKA) with conventional implantation. Analysis of alignment and of component orientation have shown both significant and non-significant differences between the two methods. Not much work has been reported on clinical evidence of stability of the joint. We compared computer-assisted and conventional surgery for TKA at 5.4 years follow-up for patients with varus osteoarthritic knees with deformity of more than 15∗. Our goal was to assess clinical outcome, stability and restoration of normal limb alignment. We used CT and Cine video
Using digital X-rays to plan a hip replacement can cause problems with sizing and templating the prosthesis. Using an AP view of both hips is desirable as this allows the use of the sometimes unaffected contralateral hip for templating. We devised a method of using a 20mm ball bearing as a marker positioned at the same depth as the greater trochanter, but between the patient's legs. Placing the marker between the patient's legs avoids the problem of the marker disappearing off the side of the X-ray, as is seen when placing the marker at the side of the obese patient. The marker is then used to calibrate the size of the digital X-ray. We used a hundred consecutive post-operative X-rays, comparing the size of the head of the femoral prosthesis used at surgery with the size measured pre-operatively using the marker.Background
Method
To evaluate Radiological changes in the lumbosacral spine after insertion of Wallis Ligament for Foraminal Stenosis. Thirty two Levels in Twenty Six patients were followed up with standardised radiographs after insertion of Wallis Ligaments for Foraminal Stenosis. Wallis ligaments as a top-off or those with prolapsed discs were not included. The Radiological parameters compared were Anterior and Posterior Disc height, Foraminal height and width, The inter-vertebral angle (IVA), Lumbar lordosis and Scoliosis if any. The presence of slips and their progression post-op was noted, as was bony lysis if any. There were ten males with thirteen levels and sixteen females with nineteen levels in the study. Eighteen levels (56.25%) were L4/L5, ten (31.25%) were L5/S1 and 4 (12.5%)were L3/L4. The average age in the series was 59.6 years (Range 37 – 89 yrs). Average follow up was 9.5 months (Range 2 to 36). The Average increase in Anterior disc height was 1.89 mm (+/−1.39), the posterior disc height increased by an average 1.09 mm (+/−1.14). Foraminal height increased by an average 3.85 mm (+/− 2.72), while foraminal width increased by 2.14 mm (+/− 1.38). The IVA increased in 16 and reduced in 15 patients, with no change in 1. Lumbar Lordosis increased in 23 patients, with an average value of 2.3°. No patient exhibited progression in scoliosis and no lysis could be identified. There were three Grade I slips pre-op; none progressed.Purpose
Methods and Results
Introduction. One of the important criteria of the success of TKR is achievement of the Flexion ROM. Various factors responsible to achieve flexion are technique, Implant and patient related. Creation of the Posterior condylar offset is one such important factor to achieve satisfactory flexion. Aim. To correlate post op femoral condylar offset to final flexion ROM at 1 yr. post op. Methods. This is a clinico-radiological study of the cases done prospectively between September 2011 and August 2012. Inclusion criteria:. All patients undergoing Bilateral TKRs and have agreed for the follow up at 1 yr. Exclusion criteria:. Patients who had previous bony surgery on lower end femur. Patients with previous fracture of lower end femur. All the patients had PS PFC Sigma (De Puy, Warsaw) components cemented. ROMs were measured at 6 weeks, 3 months, & 1 year post op. The last reading was taken as final flexion ROM as measured by a Physiotherapist with the help of a Goniometer. Results. We had 21 cases of Bilateral TKRs who satisfied our criteria. Pre and post op femoral condylar offset was measured in mm. on lateral
Introduction:. One of the important criteria of the success of TKR is achievement of the Flexion ROM. Various factors responsible to achieve flexion are technique, Implant and patient related. Creation of the Posterior condylar offset is one of the important factors to achieve satisfactory flexion. Aim:. To correlate post op femoral condylar offset to final flexion ROM at 1 yr. post op. Methods:. This is a clinico-radiological study of the cases done prospectively between September 2011 and August 2012. Inclusion criteria:. All patients undergoing Bilateral TKRs and have agreed for the follow up at 1 yr. Exclusion criteria:
. 1). Patients who had previous bony surgery on lower end femur. 2). Patients with previous fracture of lower end femur. All the patients had PS PFC Sigma (De Puy, Warsaw) components cemented. ROMs were measured at 6 weeks, 3 months, & 1 year post op. The last reading was taken as final flexion ROM as measured by an independent Physiotherapist with the help of a Goniometer. Results:. We had 21 cases of Bilateral TKRs who satisfied our criteria. Pre and post op femoral condylar offset was measured in mm. on lateral
Objectives. Total hip arthroplasty (THA) is one of the most successful surgical procedures; several bearing technologies have been used, however none of these is optimal. Metal on polycarbonate-urethane (PCU) is a new bearing technology with several potential advantages: PCU is a hydrophilic soft pliable implant quite similar in elasticity to human cartilage, offers biostability, high resistance to hydrolysis, oxidation, and calcification, no biodegradation, low wear rate and high corrosion resistance and can be coupled with large metal heads (Tribofit Hip System, THS). The aim of this prospective study was to report the survivorship and the clinical and radiographic outcomes and the metal ions dosage of a group of patients operated with metal on PCU arthroplasty featuring large metal diameter heads, at 5 years from surgery. Study Design & Methods. 68 consecutive patients treated with the THS were included. The patients have been contacted by phone call and invited to return to our centre for clinical (Oxford Hip Score, OHS, and Harris Hip Score, HHS), radiographic exam and metal ion levels evaluation. All the patients were operated with uncemented stems. Results. The survival rate is 100% and no major complications were seen. The average preoperative OHS was 17 (6–34), at follow-up it was 44 (40–48). The average preoperative HHS was 48 (12–76), at follow-up it was 93 (84–100). On the
Stems are a crucial part of implant stabilization in revision total knee arthroplasty. In most cases the metaphyseal bone is deficient, and stabilization in the diaphyseal cortical bone is necessary to keep the implant tightly fixed to bone and to prevent tilt and micromotion. While sleeves and cones can be effective in revision total joint arthroplasty, they are technically difficult and may lead to major bone loss in cases of loosening or infection, especially if the stem is cemented past the cone. A much more conservative method is to ream the diaphysis to the least depth possible to achieve tight circumferential fixation, and to apply porous augments to the undersurface of the tibial tray or inner surface of the femoral component to allow them to bottom out against the bone surface and apply compressive load. If a robust, strong taper, stem and component combination is used, rim contact on only one side is necessary to achieve rigid permanent fixation. Porous and non-porous stems are available. The non-porous stems should have a spline surface that engages the diaphyseal bone and achieves rigid initial fixation but does not provide long-term axillary support. In that way the porous rim-engaging surface can bear compressive load and finally unload the stem and taper junction. Correctly designed stems do not stress relieve unless they are porous-coated. In situations where metaphyseal bone is not available, porous-coated stems that link to hinge prostheses are a very important part of the armamentarium in complex revision arthroplasty. Use of stems requires experience and special technique. Slight underreaming and initial scratch fit are necessary techniques. This does not result in tight fixation every time because split of the cortex does occasionally occur. In most cases these splits do not need to be repaired, but when there is a question, an intra-operative
Introduction. Literature describes pelvic rotation on lateral
The lack of a universal, consistent protocol for the subjective, objective and radiographic evaluation of these injuries has hampered the comparison of results. Methods. 45 patients with complex fractures of the calcaneus were included in this prospective study, which was undertaken from July 2003 to December 2005. The fracture classification of Essex-Lopresti was used. We also observed the extent of secondary fracture lines extending from the primary shear line (on axial and external oblique plain radiographs) to establish comminution. The external oblique view for subtalar joint was performed with the patient supine, the knee at about 60 degree of flexion and the limb rotated externally 45 degree with a vertical
A retrospective descriptive preliminary study on early experience using all pedicle screw correction. Pedicle screw fixation enables enhanced correction of spinal deformities. However, the technique is still in early development in our clinic. Tends of the scoliosis patient to come in late ages make maximum correction failed. A total 16 patients are subjected to pedicle screw fixation for spinal deformities were analyzed descriptively as an early follow-up in the last two-year. 14 patients are girl and 2 are boys. The age range between 12 to 18 year. 8 are Kings type II and 8 are Kings type III, 212 screws were inserted between Th3 – L2 (14-18 screws per-patient), all concave pedicles were inserted with screws but in convex side every two or three pedicles were inserted. The position of screws was analyzed using the post-operative plain
Introduction. Proper femoral reaming is a key factor for a successful outcome in cementless hip arthroplasty. Good quality reaming minimizes risks of intra-operative femoral fracture during reaming and prevents poor fitting of the implant which can lead to subsidance of the stem postoperativly. Determining the quality of reaming is largely a subjective skill and dependant on the surgeon's experience with no documented intraoprative method to assess it objectively. Method. We recorded and analysed the frequencies of sound signals recorded via a bone conduction microphone during reaming of the femoral canal in a series of 28 consecutive patients undergoing uncemented total hip replacement performed by same surgeon. Hammaring sound frequencies and intensity were analysed by mean of computer software. The relationship between the patterns of the recorded reaming sound frequencies compared with surgeon judgment of the reaming quality intraoparativly and post operative
Introduction. Open tibial fractures are associated with increased risk of complications, particularly a higher risk of infections and decreased functional outcome. Objectives. To evaluate the incidence of complications and the functional outcomes after managing open tibial fractures with circular fine-wire fixators. Methods. Retrospective review of 35 open tibial fractures treated with circular fine-wire fixators {Ilizarov and Taylor Spatial Frame (TSF)} in a teaching hospital. Patients were reviewed with
Despite the high success rates of Reverse Shoulder replacements, complications of instability & scapular notching are a concern. Factors reducing relative motion of implant to underlying bone which include lateral offset to centre of rotation, screw & central peg insertion angle and early osteo-integration are maximized in the Trabecular Metal Reverse total shoulder system. We present clinico-radiological outcomes over 72 months. Analysis of a single surgeon series of 140 Reverse total shoulder replacements in 135 patients was done. Mean age was 72(range 58– 87 yrs); 81 females: 54 males. Indications were Rotator cuff arthropathy {n= 88} (63%); Osteo-arthritis with dysfunctional cuff {n= 22}(15%); post-trauma{n=23} (15%); revision from hemiarthroplasty {n=3} (2.4%) and from surface replacement {n=4} (2.8%). All patients were assessed using pre-operative Constants and Oxford scores and clinical & radiographic reviews with standard X-Rays at 6 weeks, 3, 6,12 months and yearly thereafter.
We undertook a comparative audit of 171 consecutive Hip and Knee Arthroplasties performed by an overseas team at an Independent Hospital (Group 1) between August 2005 and December 2005 and compared them to a corresponding number performed by all grades of surgeons at the local NHS Trust (Group 2). We examined patient selection criteria such as BMI and ASA grade and compared the early radiological outcome, complication rate, length of hospital stay and the patient satisfaction rate between the two groups. We found that patients in Group 1 had a lower average BMI (27.13) and a better ASA grade (95% grade 1 and 2) as compared to Group 2 (BMI - 29.69 and 80% ASA Grade 1 and 2). The average hospital stay was 6.1 days in Group 1 and 8 days in Group 2. Only 74% of the patients in Group 1 were completely satisfied with their treatment outcome as compared to 91% in Group 2. (Trent Arthroplasty Questionnaire). There were 7 early dislocations (9.1%) in Group 1 (76 THRs), two requiring revision, as compared to one in Group 2 (1.3%, 84 THRs). Three other patients from Group 1 (TKRs) required a revision procedure within the first year. There was an increased incidence of adverse features (mal-alignment and mal-positioning of components) on the post operative
Hypothesis. The use of cartilage compensated virtual standing CT images for pre surgical planning improves the reliability of preoperative planning. Materials and Method. Sampling included in this study were > 62 years of age (mean age 58.17 yrs ±3.54 yrs, range 55–62) with symptomatic isolated medial osteoarthritis, genu varum (mean varus 5.6°±2.6 °, range 2.1°–8.6°), good range of motion (flexion > 90° and flexion contracture < 10°) and with minimal ligamentous instability. All subjects had obtained a pre-op CT scan, MRI scan and weight-bearing long bone
Purpose. In 2010, the new clinical guideline of Osteoporosis Canada for the diagnosis of osteoporosis, clearly indicates that patients with high-risk of fracture are those that have already sustained a fracture (osteoporotic fracture). Until now, only 12% of the 3,400 fractures that we treat each year receive a treatment for osteoporosis. We are validating an evaluation protocol and a multidisciplinary systematic follow-up approach for osteoporosis. Patients are managed by a clinical nurse specialist. We are recruiting 543 patients with an osteoporotic fracture at Hal du Sacré-Coeur de Montréal. We aim to evaluate: 1) the incidence of a second osteoporotic fracture, 2) the initiation of a treatment and determine the compliance and adherence to treatment and 3) the evaluation of CTX-1 and Osteocalcin at Baseline, 6, 12,18 et 24 months (treatment efficacy) and 4) the functional outcome and quality of life post-fracture. Method. We've enrolled 153 subjects (men and women) over 40 years of age who were treated for an osteoporotic fracture at the orthopaedic clinic of Hal du Sacré-Coeur de Montréal. After starting a treatment protocol for osteoporosis, the subjects will be followed for a 24 months period at different time intervals. During these visits, they fill up functional outcome questionnaires, undergo physical exam, blood test,