Introduction. It is essential to investigate the tribological maturation of tissue-engineered cartilage that is to be used in medical applications. The frictional performances of tissue engineered cartilage have been measured using flat counter surfaces such as stainless steel, glass or ceramics. However, the measured friction performances were significantly inferior to those of natural cartilage, likely because of cartilage adhesion to the counter surface. Tamura et al. reported that a poly (2- methacryloyloxyethyl phosphoryl-choline (MPC)) grafted surface shows low friction coefficient against cartilage without the adhesion to be equivalent to those for natural cartilage-on-cartilage friction. [1]. On the other hand, Yamamoto et al. reported that applying a relative sliding movement had a potential to alter the expression of tribological function of regenerated cartilage of chondrocytes. [2] In this paper, the effects of the relative sliding movement on the expression of bone marrow stromal cells (BMSC)s were investigated using the poly(MPC) grafted surface as a counter surface. Material and methods. BMSCs seeded onto fibroin sponge scaffolds were cultured by using the stirring chamber system (Figure 1), which can apply a relative tribological movement to the surface of the specimens. Three culture conditions were applied (dynamic in stirring chamber as frequency as 40 min [D1], as 40 sec [D2] and static in stirring chamber group [S]). The specimens were set into stirrer on a poly(MPC) grafted surface (MPC polymer coated surface, SANSYO). As a counter surface in friction tests, the poly(MPC) grafted surface was prepared by atom transfer radical polymerization, and the regenerated cartilage was prepared by seeding 5×10. 5. cells (BMSCs from rat bone marrow) onto fibroin sponge scaffolds (8 mm diameter and 1 mm thickness) and by 14 days culture. Results and Discussion. The friction coefficient in D1 group tended to be lower than that in S group. Similarly, D2 group tended to show lower value than S group (Figure 2). However, the value of D1 and D2 group was extraordinary high, compared to that of intact articular cartilage. The GAG amount of D1 and D2 group was significantly higher than that of S group. All of the groups showed Collagen type I and type II staining at the surface. S group showed wider staining region than D1 and D2 group. However there was no Alcian Blue staining (Figure 3). These results indicate that the stirring chamber system tended to improve the frictional performance of regenerated tissue. However this relative tribological movement has not a potential to induce effects on the differentiation of BMSCs to chondrocytes

An established rabbit model was used to preliminarily investigate the effect of acellular triphase, namely bone-cartilage-tendon, scaffold (ATS) sandwiched with autologous bone mesenchymal stem cells (BMSCs) sheets on tendon-bone interface healing. Bone, fibrocartilage and tendon tissue were harvested from the rabbits and sectioned into a book-type scaffold. The scaffolds were decellularized and their characterization was presented. BMSCs were isolated and co-cultured with the scaffolds to verify their cytocompatibility. BMSCs sheets were fabricated and inserted into the book page of the scaffold to construct an autologous BMSCs-sheets/book-type ATS complex. The complex was implated in the right knee of rabbits which operated standard partial patellectomy for TBI regeneration using Imaging, histological and biomechanical examinations. The bone, fibrocartilage and tendon tissue were sectioned into a book-type scaffold before decellularization. Then we decellularized the above tissue and mostly preserved their microstructure and composition of the natural extracellular matrix, including collagen and proteoglycan. After the physicochemical and biological properties of the book-type ATS were evaluated, autologous BMSCs sheets were inserted into the book page of the scaffold to construct an autologous BMSCs-sheets/book-type ATS implants for TBI regeneration. In addition, the ATS has the advantages of non-toxicity, suitable for cell adhesion and growth as well as low immunogenicity while co-cultured with the BMSCs. At the same time, different scaffolds has the ability to induce the osteogenic, chondrogenic and tenogenic differentiation of BMSCs by immunofluorescence, reverse transcription-polymerase chain reaction and western blot analysis. To determine the efficacy of the tissue-engineered implants for TBI regeneration, we transplanted it into a rabbit patella-patellar tendon (PPT) injury model, and the rabbits were sacrificed at postoperative week 8 or 16 for the radiological, histological, and mechanical evaluation. Radiologically, Synchrotron radiation micro-computed tomography (SR-μCT) showed that BMSCs/ATS group significantly increased bone area, BV/TV, trabecular thickness and trabecular number at the healing interface as compared with other groups at postoperative week 8 or 16. Histologically, the BMSCs/ATS group showed more woven bone, and a more robust fibrocartilaginous junction with a characteristic matrix rich in proteoglycans was seen at the PPT healing interface in comparison with other groups after 8 weeks. At week 16, the healing interface in 3 groups displayed better remodeling with respect to postoperative week 8. Healing and remodeling at the PPT junction were almost complete, with a resemblance to a healthy BTI consisting of the characteristic 4 zones in all groups. At last, we used biomechanical test as functional parameters to evaluate the quality of tendon-bone healing. Biomechanical testing indicated that BMSCs/ATS group showed significantly higher failure load and stiffness than other groups at postoperative week 8 and 16. The complex composed of acellular triphase, namely bone-cartilage-tendon, scaffold (ATS) sandwiched with autologous bone mesenchymal stem cells (BMSCs) sheets can simulate the gradient structure of tendon-bone interface, inducing stem cell directional differentiation, so as to promote patella-patellar tendon interface healing effectively after injury

Bone marrow-derived mesenchymal stromal stem cells (BMSCs) are a promising cell source for treating articular cartilage defects. Quality of cartilaginous repair tissue following BMSC transplantation has been shown to correlate with functional outcome. Therefore, tissue-engineering variables, such as cell expansion environment and seeding density of scaffolds, are currently under investigation. The objectives of this study were to demonstrate chondrogenic differentiation of BMSCs seeded within a collagen I scaffold following isolation and expansion in two-dimensional (2D) and three-dimensional (3D) environments, and assess the impact of seeding density on in vitro chondrogenesis. It was hypothesised that both expansion protocols would produce BMSCs capable of hyaline-like chondrogenesis with an optimal seeding density of 10 million cells/cm3. Ovine BMSCs were isolated in a 2D environment by plastic adherence, expanded to passage two in flasks containing expansion medium, and seeded within collagen I scaffolds (6 mm diameter, 3.5 mm thickness and 0.115 ± 0.020 mm pore size; Integra LifeSciences Corp.) at densities of 50, 10, 5, 1, and 0.5 million BMSCs/cm3. For 3D isolation and expansion, bone marrow aspirates containing known quantities of mononucleated cells (BMNCs) were seeded on scaffolds at 50, 10, 5, 1, and 0.5 million BMNCs/cm3 and cultured in expansion medium for an equivalent duration to 2D expansion. All cell-scaffold constructs were differentiated in vitro in chondrogenic medium containing transforming growth factor-beta three for 21 days and assessed with RT-qPCR, safranin O staining, histological scoring using the Bern Score, collagen immunofluorescence, and glycosaminoglycan (GAG) quantification. Two dimensional-expanded BMSCs seeded at all densities were capable of proteoglycan production and displayed increased expressions of aggrecan and collagen II mRNA relative to pre-differentiation controls. Collagen II deposition was apparent in scaffolds seeded at 0.5–10 million BMSCs/cm3. Chondrogenesis of 2D-expanded BMSCs was most pronounced in scaffolds seeded at 5–10 million BMSCs/cm3 based on aggrecan and collagen II mRNA, safranin O staining, Bern Score, total GAG, and GAG/DNA. For 3D-expanded BMSC-seeded scaffolds, increased aggrecan and collagen II mRNA expressions relative to controls were noted with all densities. Proteoglycan deposition was present in scaffolds seeded at 0.5–50 million BMNCs/cm3, while collagen II deposition occurred in scaffolds seeded at 10–50 million BMNCs/cm3. The highest levels of aggrecan and collagen II mRNA, Bern Score, total GAG, and GAG/DNA occurred with seeding at 50 million BMNCs/cm3. Within a collagen I scaffold, 2D- and 3D-expanded BMSCs are capable of hyaline-like chondrogenesis with optimal cell seeding densities of 5–10 million BMSCs/cm3 and 50 million BMNCs/cm3, respectively. Accordingly, these densities could be considered when seeding collagen I scaffolds in BMSC transplantation protocols

INTRODUCTION. Trabecular Titanium. ™. (TT) is a novel material with a structure similar to trabecular bone, already used for prosthetic clinical applications. Being the bone-implant interface the weakest point during the initial healing period, the association of TT with a hydrogel enriched with progenitor cells and osteoinductive factors may represent a promising strategy to improve prosthesis osteointegration. In a previous in vitro study we evaluated the ability of an ammidated carboxymethylcellulose hydrogel (CMCA) and of TT enriched with CMCA to support bone marrow mesenchymal stem cells (BMSCs) viability and osteogenic differentiation [1]. The aim of this study was to evaluate in vivo if the association of TT with CMCA enriched with strontium chloride (SrCl. 2. ) and BMSCs could ameliorate TT osteointegration. METHODS. This study combines TT with CMCA, SrCl. 2. and BMSCs. To mimic prosthesis-bone implants, TT discs were seeded with human BMSCs predifferentiated in osteogenic medium, then press-fit into engineered bone. A total of 36 athymic mice were implanted subcutaneously, each animal received 2 constructs as un-seeded TT and TT+CMCA or cell seeded TT+BMSCs and TT+CMCA+BMSCs. After 4, 8 and 12 weeks, osteodeposition, bone mineral density (BMD) and osteointegration were evaluated by fluorescence imaging, micro-CT, SEM, histology and pull-out tests. RESULTS. Micro-CT analysis demonstrated the homogeneity of the engineered bone in all experimental groups, supporting the reproducibility of our novel engineered model. Macroscopic evaluation of explanted constructs after 4 weeks revealed their integration with mice subcutaneous structures. In pull-out biomechanical tests, increases in extraction energy and peak force from 4 to 12 weeks were observed in all the experimental groups, except TT+CMCA. TT+CMCA+BMSCs showed the highest value of peak force and the greatest increase in comparison to samples explanted at 4 weeks. In vivo fluorescence imaging showed osteodeposition activity inside the constructs, observation confirmed by the ex-vivo analyses revealing a higher activity in TT+BMSCs and in TT+CMCA+BMSCs in comparison to acellularized TT samples. SEM evaluation of ECM deposition at the interface between bone scaffolds and TT disks revealed a significant difference between TT+CMCA+BMSCs and the other experimental groups with the former showing an almost complete filling of the space between the integration surfaces already after 4 weeks. In histomorphometric analyses of tissue ingrowth at 8 weeks, TT+BMSCs and TT+CMCA+BMSCs showed a greater tissue ingrowth compared to TT and TT+CMCA samples. DISCUSSION. Several efforts have been made to improve osteointegration with particular attention to critical cases such as implant revision surgeries. The association of porous structures with osteoinductive factors enriched hydrogels and stem cells represents a novel and promising strategy for more effective osteointegration to reduce prosthesis mobilization risks. Our results demonstrate that the association of Trabecular Titanium. ™. with a SrCl. 2. enriched hydrogel and BMSCs increases the production of ECM and may thus represent a valid approach to accelerate prosthesis osteointegration. Further validation of these data will include construct implantation in large animal orthotopic models to better mimic surgical procedures

Purpose. The biomechanical role of the meniscus in the knee joint is a function of its extracellular matrix which consists of type I collagen throughout, type II collagen in the inner meniscus region and glycosaminoglynated (GAG) proteins of which aggrecan is the most prevaleet. Meniscus reparative capacity is limited, particularly when a defect is located in the inner avascular portion, and menisectomy predisposes the joint to osteoarthritis. Using meniscus cells in tissue engineering strategies has been advocated to generate functional meniscus substitutes. However, meniscus cells, like chondrocytes of cartilage, lose their matrix-forming phenotype during culture expansion. Co-culture of chondrocytes with stem cells has been shown to result in enhanced matrix formation. We hypothesized that meniscus cells in co-culture with stem cells will result in increased matrix formation. Method. Tissue specimens were obtained after approval of the local ethical committee and informed consent. Menisci were obtained from 3 patients undergoing total knee arthroplasty; (53–84; mean age 66.6). Meniscus cells were isolated after digestion of menisci with collagenase II. Isolated meniscus cells were plated for 24–48 hr before use. Bone marrow aspirates were obtained from the iliac crest of 3 donors: 1 female (46) and 2 males (15 and 21) undergoing routine orthopaedic procedures. Plastic adherent bone marrow stromal cell populations were isolated and expanded under normal oxygen tension of 21%O2 in a-MEM growth media plus FGF-2 until passage 2. Cells were mixed at a variety of meniscus cells (Men): BMSC ratio including 5/95, 10/90 and 25/75, respectively. Mixed cells were centrifuged to form spherical pellets followed by culture in a defined serum free chondrogenic differentiation medium. Control groups were pure Men and pure BMSCs. Total cell number per pellet was 25×104. Pellets were cultured for 3 weeks under normal oxygen tension. Thereafter, pellets were processed: biochemically for GAG and DNA content, and histologically for Safranin-O staining of sulphated GAG and immunohistochemical analyses for collagen types I and II. Analysis was performed on a minimum of 2 independent pellets. Results. Relative to pure cell control pellets, co-cultured cell pellets of expanded human BMSCs and meniscus cells had more GAG matrix per DNA content. The amplitude of GAG enhancement in all co-cultures varied with donor and with the Men:BMSC ratio. However, the mean GAG enhancement was 1.8–6 fold. The GAG contents of pellets correlated with Safranin-O staining. Positive staining for collagens types I and II was increased in co-cultured cell pellets. Conclusion. Co-seeding of meniscus cells and stem cells on a suitable scaffold may aid the generation of functional grafts with improved biomechanical properties relative to those generated via expanded meniscus cells alone or stem cells alone