The volume of blood evacuated from the knee joint, The calculated total blood loss, Time to discharge, range of movement and incidence of wound problems.
In vitro studies recommend concentric placement of the acetabular component. There are however no in vitro studies on acetabular component positioning.
28 knees underwent full clinical and radiological review at a mean of 25.8 months post-operatively, using the Hospital for Special Surgery Score and the Knee Society Score. 2 patients were interviewed by phone with recent radiological follow-up. One patient had died from unrelated causes.
The mean pre-operative alignment for the primary arthroplasties was 28° for the varus and 32° for the valgus knees. The mean postoperative alignment was 7°. The mean Hospital for Special Surgery score was 72.4 for primary arthroplasties and 72.7 for revision surgery. The mean Knee Society Knee Score was 79.8 and 75.1 respectively, and the mean Functional Score was 60.8 and 49.4 respectively. The latter reflects the elderly age, multiple joint involvement and constitutional status (including rheumatoid arthritis) of many of these patients. 4 patients experienced retropatellar pain. One patient with severe rheumatoid developed sepsis of the revision implant. Difficulties with tibial tray lateralisation and stem fixation will be discussed.
Most surgeons consider the arthroscope tip or light cable end to be the site most likely to induce combustion. Fuel, heat and oxygen are required to produce combustion. Direct contact with the tip results in greater exposure to heat but lower oxygen availability. The fasted combustion occurred at 5mm due to higher oxygen availability despite a lower temperature.
Disposable drapes will burn with the light cable and the arthroscope tip. The arthroscope tip and light cable end should not be left to rest against the drapes because thermal burns can occur within seconds. A kidney dish should be used to contain the instruments when not in the surgeon’s hands. The light source should be switched on only when the light cable is connected to the arthroscope. A retractable shield of 2.5mm is fitted to the light cable end.