Tightrope fixation is known method for reconstructing acromioclavicular joint and the presence of good bone stock around the two drillholes is the most important determining factor for preventing failure. Arthroscopic-assisted tightrope stabilisation involve drilling clavicle and coracoids in a straight line. This leads to eccentric drillholes with inadequate bone around it. Open tightrope fixation involves drilling holes under direct vision, independently and leading to centric hole with adequate bone around it. Our study assesses the hypothesis of tightrope fixation in relation to location of drillholes using CT-scan and cadaveric models for arthroscopic and open technique for ACJ fixation. CT-scans of 20 shoulders performed. Special software used to draw straight line from distal end of clavicle to coracoid. Bone volume around coracoid drillhole was calculated. Cadaveric shoulder specimens were dissected. The arthroscopic technique was performed under vision by drilling both clavicle and base of coracoid holes in one direction. Same specimens were used for open technique. Base of coracoid crossectioned and volume calculated.Aim
Methods
Recurrent shoulder dislocation is associated with bony defect of the glenoid rim, commonly seen along with bankart tear - a soft tissue injury of glenoid labrum. This cadaveric study compares the bone block effect of coracoid transfer using using two common techniques, Classical Latarjet technique and the Congruent-Arc Latarjet. We hypothesized that the force needed to dislocate the shoulder would be greater in Congruent Arc technique than the Classical Latarjet, because of increased contact surface area as a result of greater linear dimensions. We dissected 14 cadaveric shoulders. A bony Bankart lesion was created in form of an inverted pear glenoid. The humeral head was attached to a pulley system that was sequentially loaded until the shoulder dislocated anteriorly. The force needed to dislocate was noted. This was repeated after coracoid transfer with two common techniques, Classical Latarjet technique and the Congruent-Arc Latarjet.Hypothesis
Material and methods
The National Institute for Clinical Excellence, UK published guidelines in 2007 encouraging the use of low molecular weight heparin (LMWH) joint replacement surgery. Subsequently, our hospital adopted these guidelines in the treatment of total hip replacements. This study is based on our prospective database of total hip replacements between 2005 and 2009 and compares the complication and mortality rates pre- and post institution of the NICE guidelines. We analysed prospectively collected data on 686 patients who underwent a primary total hip replacement done by a single surgeon between January 2005 and April 2009. We compared the incidence of mortality, pulmonary embolism, myocardial infarction and intracranial bleeding between the two groups. Prior to the guidelines, all patients were treated for the duration of their admission with 75mg aspirin followed by 4 weeks after discharge. Subsequent to the guidelines, the treatment changed to 40mg of LMWH (Clexane) while an inpatient with aspirin being prescribed for 4 weeks on discharge. Patients unable to tolerate aspirin were treated with low molecular weight heparin. High risk patients (previous pulmonary embolism, previous deep vein thrombosis, family history) were treated with 6 weeks of warfarin. Each patients was reviewed at 8 weeks and 6 months following surgery, and adverse incidents were documented at each review or incident.