Abstract
Introduction
The hip-knee-ankle (HKA) angle between the mechanical axis of the femur (FM) and the mechanical axis of the tibia (TM) is the standard parameter to assess the coronal alignment of the lower extremity. TM is the line between the center of the tibial spines notch (Point T) and the center of the tibial plafond. However, this theory is based on the premise that TM coincides the anatomical axis of the tibia (TA). Fig.1a shows typical varus knee with medial shift of the tibial articular surface. In this case, TM does not coincide TA. Fig. 2 demonstrates the error of HKA angle when Point T locates medial to TA. Fig.2a shows normal alignment. Fig.2b shows varus alignment. Fig. 2c shows the tibia with medial shift of the tibial articular surface. The tibia has 7 degrees varus articular inclination in Fig.2b and 2c. However, HKA angle is 0 degree in Fig.2c. HKA angle underestimates varus deformity in knees with medial shift of the tibial articular surface. However, the degree of medial shift of the tibial articular surface is obscure. In this study, detailed anatomical configuration of the proximal tibia was evaluated. The effect of the value of HKA angle on the coronal alignment in TKA was then discussed.
Methods
This study consists of 117 knees. On the AP view radiograph of the tibia, three distance and two angle parameters were measured. Those were tibial articular surface width, distance between medial edge of the tibial articular surface and Point T, distance from TA to Point T. Angle between TM and TA, and the varus inclination angle of the tibial articular surface relative to the perpendicular line to TA.
Results
The mean width of the tibial articular surface was 87.8mm. The mean distance between Point T and medial edge of the articular surface was 43.6mm. Point T located at the center of the tibial articular surface. The mean distance from TA to Point T was 5.6mm. The mean angle between TM and TA was 1.0 degrees. The inclination angle of the tibial articular surface was 8.2 degrees.
Discussion
The results clearly showed that varus knees had medial shift of the tibial articular surface. In such knees, the ankle shifts laterally relative to the Point T and HKA angle underestimates the varus deformity.
The value of HKA angle also influences the evaluation of the coronal alignment of the lower extremity in TKA (Fig. 3). When the tibial tray is set based on the tibial articular surface width in order to cover the cut surface of the tibia, HKA angle shows the alignment as valgus when the tibial tray is set perpendicular to TA (Fig. 3a). In order to obtain zero degree of HKA angle, the tibial tray should be set perpendicular to TM. This alignment is varus (Fig. 3b).
Reduction osteotomy is one procedure to match the value of HKA angle and the true alignment (Fig. 3c). In this technique, HKA angle is zero degree, and TM and TA coincide.
For figures, please contact authors directly.
