Abstract
Introduction
Since 1989 we have been using custom lateral-flare stems. Using this stem, its lateral flare can produce high proximal fit and less fit in distal part. Applying this automatic designing software to the average femoral geometries, we can make off the shelf high proximal fit stem (Revelation ®). Putting the off the shelf stem, the original center of the femoral heads were well reproduced. But in DDH cases, severe deformities around hip sometimes make complicated difficulty for better functional reconstruction. They are high hip center such as Crowe II-IV, shortening of the femoral neck, high anteversion etc. DDH cases are well known to have higher anteversion than non DDH cases. There would be no definite explanations for it. The high anteversion would not always be harmful for the preoperative patients. But in some cases, osteophytes are observed at posterior side of the femoral head which make another sphere with different centre. We can guess that the patient's biomechanics had not been matched with the original anteversion. Then posterior osteophytes can correct inappropriate anteversion (self-reduction.) (Fig.1) In those patients, reduction of the anteversion by putting stems twisted into the canal or using modular stems are sometimes done by the surgeons' decision.
Younger DDH cases can also be treated with THA, because of the complicated deformities or biomechanical disorders. Short stems are expected to reduce operative invasion and stress shielding then can reserve bone quality and quantity. From these point of view to improve the understanding of the characteristics of the DDH anteversion, and design a DDH oriented short stem could be one of good solution for those cases.
Method
-
For the better understanding of the high anteversion 57 femora (mean anteversion: 34.4 deg.) were analyzed slice by slice. The direction of femoral head centre, lesser trochanter (LTR), linea aspera (aspera) just below LTR, aspera in the middle of the femur and aspera between the last 2 sections. All of the directions were assessed from PC line
-
To clarify the meaning of the head osteophytes, 35 operated cases were analyzed the extent of the head osteophytes.
-
According to the results, a DDH oriented short stem was designed.
Results
-
Even with the different anteversion, femoral head centres and LTRs were located within limited angle (51.4 +/−7.9 deg.) But aspera just below the LTR had no relation to the LTR direction, but always kept within limited angle (102.0 +/− 4.5) to the PC line. This means that DDH cases have proximal femurs of normal shape. But they are only twisted around the level just below the LTR. From this result, stems for DDH cases can have the same shape with normal stem inside the canal.
-
The posterior osteophytes had reduced 4.6+/− 3.0 degree in average independently to the extent of anteversion. There was no tendency that higher anteversion cases have higher self-reduction angle.
-
the stems were give the same shape inside the canal with stems for non DDH cases but its femoral head center was located with 5 degrees less anteversion.
