Abstract
Metaphyseal bone loss, due to loosening, osteolysis or infection, is common with revision total knee arthroplasty (TKA). Small defects can be treated with screws and cement, bone graft, and non-porous metal wedges or blocks. Large defects can be treated with bulk structural allograft, impaction grafting, or highly porous metal cones. The AORI classification of bone loss in revision TKA is very helpful with preoperative planning. Type 1 defects do not require augments or graft—use revision components with stems. Type 2A defects should be treated with non-porous metal wedges or blocks. Type 2B and 3 defects require a bulk structural allograft or porous metal cone. Trabecular metal (TM) metaphyseal cones are a unique solution for large bone defects. Both femoral (full or partial) and tibial (full, stepped, or cone+plate) TM cones are available. These cones substitute for bone loss, improve metaphyseal fixation, help correct malalignment, restore joint line, and permit use of a short cemented stem. The technique for these cones involve preparing the remaining bone with a high speed burr and rasp, followed by press-fit of the cone into the remaining metaphysis. The interface is sealed with bone graft and putty. The fixation and osteoconductive properties of the outer surface allow ingrowth and biologic fixation. The revision knee component is then cemented into the porous cone inner surface, which provides superior fixation compared to cementing into deficient metaphyseal bone. The advantages of the TM cone compared to allograft include: technically easier; biologic fixation; no resorption; and lower risk of infection. The disadvantages include: difficult extraction and intermediate-term follow-up. The author has reported the results of 33 TM cones (9 femoral, 24 tibial) implanted in 27 revision cases at 2–5.7 years follow-up. One knee (2 cones) was removed for infection. All but one cone showed osseointegration. TM cones are now the preferred method for the reconstruction of large bone defects in revision TKA.
