Abstract
Despite reverse total shoulder arthroplasty (RTSA) being primarily indicated for massive rotator cuff tears, it is often possible to repair portions of the infraspinatus and subscapularis of patients undergoing this procedure. However, there is disagreement regarding whether these tissues should be repaired, as their effects remain unclear. Therefore, we investigated the effects of rotator cuff repair and changes in humeral and glenosphere lateralisation (HLat & GLat) on deltoid and joint loading.
Six shoulders were tested on an in-vitro muscle driven active motion simulator. Cuff tear arthropathy was simulated in each specimen, which was then implanted with a custom adjustable RTSA fitted with a six axis load sensor. We assessed the effects of 4 RTSA configurations (i.e. all combinations of 0&10mm of HLat & GLat) on deltoid force, joint load, and joint load angle during abduction with/out rotator cuff repair. Deltoid and joint loads recorded by the load cell are reported as a % of Body Weight (%BW). Repeated measures ANOVAs and pairwise comparisons were performed with p<0.05 indicating significance.
Cuff repair interacted with HLat & GLat (p=0.005, Fig. 1) such that with no HLat, GLat increased deltoid force without cuff repair (8.1±2.1%BW, p=0.012) and this effect was significantly increased with cuff repair (12.8±3.2%BW, p=0.010). However, adding HLat mitigated this such that differences were not significant. HLat and GLat affected deltoid force regardless of cuff status (−2.5±0.7%BW, p=0.016 & +7.7±2.3%BW, p=0.016, respectively). Rotator cuff repair did significantly increase joint load (+11.9±2.1%BW, p=0.002), as did GLat (+13.3±1.5%BW, p<0.001).
The increases in deltoid and joint load caused by rotator cuff repair confirm that it acts as an adductor following RTSA and increases deltoid work. Additionally, cuff repair's negative effects are exacerbated by GLat, which strengthens its adduction affect, while Hlat increases the deltoid's abduction effect thus mitigating the cuff's antagonistic effects. Cuff repair increases concavity compression within the joint; however, Hlat produces a similar effect by wrapping the deltoid around the greater tuberosity – which redirects its force – and does so without increasing the magnitude of muscle and joint loading. The long-term effects of increased joint loading due to rotator cuff repair are unknown, however, it can be postulated that it may increase implant wear, and the risk of deltoid fatigue. Therefore, RTSA implant designs which improve joint compression without increasing muscle and joint loading may be preferable to rotator cuff repair.
