Abstract
When dealing with the patella in total knee arthroplasty (TKA) there are three philosophies. Some advocate resurfacing in all cases, others do not resurface, and a third group selectively resurfaces the patella. The literature does not offer one clear and consistent message on the topic. Treatment of the patella and the ultimate result is multifactorial. Factors include the patient, surgical technique, and implant design. With respect to the patient, inflammatory versus non-inflammatory arthritis, pre-operative presence or absence of anterior knee pain, age, sex, height, weight, and BMI affect results of TKA. Surgical technique steps to enhance the patellofemoral articulation include: 1) Restore the mechanical axis to facilitate patellofemoral tracking. 2) Select the appropriate femoral component size with respect to the AP dimension of the femur. 3) When performing anterior chamfer resection, measure the amount of bone removed in the center of the resection and compare to the prosthesis. Do not overstuff the patellofemoral articulation by taking an inadequate amount of bone. 4) Rotationally align the femur appropriately using a combination of the AP axis, the transepicondylar axis, the posterior condylar axis, and the tibial shaft axis. 5) If faced with whether to medialise or lateralise the femoral component, always lateralise. This will enhance patellofemoral tracking. 6) When resurfacing the patella, only evert the patella after all other bony resections have been performed. Remove peripheral osteophytes and measure the thickness of the patella prior to resection. Make every effort to leave at least 15 mm of bone and never leave less than 13 mm. 7) Resect the patella. The presenter prefers a freehand technique using the insertions of the patellar tendon and quadriceps tendon as a guide, sawing from inferior to superior, then from medial to lateral to ensure a smooth, flat, symmetrical resection. Medialise the patellar component and measure the thickness of reconstruction. 8) When not resurfacing the patella, surgeons generally remove all the peripheral osteophytes, and some perform denervation using electrocautery around the perimeter. 9) Determine appropriate patellofemoral tracking only after the tourniquet is released. 10) Close the knee in flexion so as not to tether the soft tissues about the patella and the extensor. With or without patellar resurfacing, implant design plays in important role in minimizing patellofemoral complications. Newer designs feature a so-called “swept back” femur in which the chamfer resection is deepened, and patellofemoral overstuffing is minimised. Lateralizing the trochlear groove on the anterior flange, orienting it in valgus alignment, and gradually transitioning to midline have improved patellofemoral tracking. Extending the trochlear groove as far as possible into the tibiofemoral articulation has decreased patellofemoral crepitation and patellar clunk in posterior stabilised designs. With respect to the tibial component, providing patellar relief anteriorly in the tibial polyethylene has facilitated range of motion and reduced patellar impingement in deep flexion. On the patella side, the all-polyethylene patella remains the gold standard. While data exist to support all three viewpoints in the treatment of the patella in TKA, it is the presenter's opinion that the overwhelming data support patella resurfacing at the time of primary TKA. It is clear from the literature that the status of the patellofemoral articulation following TKA is multifactorial. Surgical technique and implant design are key to a well-functioning patellofemoral articulation. Pain is the primary reason patients seek to undergo TKA. Since our primary goal is to relieve pain, and there has been a higher incidence of anterior knee pain reported without patellar resurfacing, why not resurface the patella?
