Abstract
Important issues related to total hip replacement for dysplasia are: placement of the cup and bone stock; the role of femoral osteotomy, and the choice of acetabular and femoral components.
The cup can be placed at the correct or near correct anatomical level with or without a bone graft, in a high position (high hip center) or at the right level in a protruded position. All three techniques can provide adequate coverage of the cup. In the high hip position bone graft is not usually necessary to obtain cup coverage. There is however a higher rate of component loosening, a higher dislocation rate, and lengthening is limited to the femoral side. Placing the cup in a protruded position to obtain coverage does not restore bone stock for future surgery, but it does place the hip at the correct level. Placing the cup in the correct anatomical position (i.e. at the right level and not protruded) may require a structural autograft which adds to the complexity of the case. However, bone stock is restored for future surgery. In a radiographic study of 31 shelf grafts with an average follow-up of 14 years, 22 grafts had mild resorption, and 9 moderate resorption. Ten patients required cup revision, 2 at 9 years, 2 at 10 to 15 years, and 6 at over 15 years. Only 2 hips required another structural graft.
Femoral osteotomy may be used as part of the exposure for diaphyseal shortening or for derotation of excessive anteversion. The osteotomy is carried out in the sub-trochanteric region and may be oblique, step-cut or transverse. Fixation of the osteotomy is achieved via the stem, a plate, or a cortical strut.
Cementless components are usually used because of the relatively young age of this patient population. Small components may be necessary. On the femoral side, the stem should be straight or modular so excessive anteversion can be neutralised.
