Abstract
Obtaining adequate exposure is key to optimising outcomes in revision total knee arthroplasty. Goals of the exposure include protecting the extensor mechanism, safe removal of the components that are in place and implantation of the revision components. Challenges to these goals include prior skin incisions, arthrofibrosis, and patella baja.
Choosing a skin incision is the first important step. The blood supply to the skin is predominantly derived MEDIALLY and thus the most LATERAL skin incision that works for obtaining exposure is selected. If skin flaps are required, they MUST be full thickness as the blood supply to the skin runs deep just over the fascial layer and partial thickness flaps risk skin necrosis. Avoid acute angles between old skin incisions of <60 degrees and skin bridges, if necessary, must be at least 6cm in width.
The work-horse of revision TKA is the medial parapatellar approach. It includes a generous medial release that allows the surgeon to externally rotate and deliver the tibia by pivoting on the extensor mechanism. An anterior synovectomy is then performed to re-establish the medial and lateral gutters followed by re-establishment of the space behind the patellar tendon to free it from the proximal tibia and finally subluxation of the patella (preferable to formal eversion). A lateral release (or peel of the soft tissue off of the lateral side of the patella) is a final step to mobilise the extensor mechanism (if required). After the components are removed, a posterior capsulectomy is performed followed by re-establishment of the flexion space behind the femur further enhances tibial exposure for both bony preparation and revision component implantation.
If the above maneuvers are performed, and exposure is still inadequate, the easiest way to improve exposure is by performing a quadriceps snip. This is an oblique, apical extension of the arthrotomy ACROSS THE PATELLAR TENDON (NOT in the muscle; it is hard to repair if performed in the muscle). It is repaired side to side with no need to alter post-operative physical therapy and heals reliably.
The V-Y Quadricepsplasty is a proximal release of the extensor mechanism; essentially perform by connecting the apical extension of the medial parapatellar arthrotomy with a lateral release across the quadriceps tendon. It is classically indicated for patients with extensor mechanism contracture where the surgeon wishes to lengthen it. It usually results in increased flexion at the expense of an extensor lag and is used rarely in contemporary practice.
Tibial Tubercle Osteotomy is a distal release of the extensor mechanism that is most useful for accessing the canal to remove long-stemmed cemented tibial components. It is a coronal osteotomy made from the medial side of the tubercle that is usually made 5–8 cm in length, tapering from approximately 1cm thick proximally to 5mm distally.
