Abstract
Summary Statement
Corin has developed bone conserving prosthesis (MiniHip™) to better replicate the physiological load distribution in the femur. This study assessed whether the MiniHip™ prosthesis can better match the pre-osteoarthritic head centre for patient demographics when compared to contemporary long stem devices.
Introduction
Leg length and offset discrepancy resulting from Total Hip Replacement (THR) is a major cause of concern for the orthopaedic community. The inability to substitute the proximal portion of the native femur with a device that suitably mimics the pre-operative offset and head height can lead to loss of abductor power, instability, lower back pain and the need for orthodoses. Contemporary devices are manufactured based on predicate studies to cater for the variations within the patient demographic. Stem variants, modular necks and heads are often provided to meet this requirement. The number of components and instruments that manufacturers are prepared to supply however is limited by cost and an unwillingness to introduce unnecessary complexity. This can restrict the ability to achieve the pre-osteoarthritic head centre for all patient morphologies. Corin has developed MiniHip™ to better replicate the physiological load distribution in the femur. This study assessed whether the MiniHip™ prosthesis can better match the pre-osteoarthritic head centre for patient demographics when compared to contemporary long stem devices.
Methods
The Dorr classification is a well accepted clinical method for defining femoral endosteal morphology. This is often used by the surgeon to select the appropriate type and size of stem for the individual patient. It is accepted that a strong correlation exists between Flare Index (FI), characterising the thinning of cortical walls and development of ‘stove-pipe’ morphology, and age, in particular for females. A statistical model of the proximal femur was built from 30 full length femoral scans (Imorphics, UK). Minimum and maximum intramedullary measurements calculated from the statistical model were applied to relationships produced by combining Corins work with that of prior authors. This data was then used to generate 2D CAD models into which implants were inserted to compare the head centres achievable with the MiniHip™ compared to those of a contemporary long stem.
Results
Results for the CAD overlay indicated the MiniHip prosthesis is better suited to restoring head centre for a range of morphological variations. In contrast, the long stem prosthesis requires a larger size range and increased inventory in terms of stem variants and modular components to achieve the same array of head centres. The disparity between the Corin FI and that of prior authors can be accounted for by the methods employed; the greyscale-based edge detection (Imorphics) compared to a manual identification method.
Discussion/Conclusion
By overlaying the Corin MiniHip™ over the CAD representation of anticipated flare index, it is evident that the MiniHip™ stem is more suitable for the anticipated range of morphologies. The versatility of this design enables the restoration of head height and offset regardless of canal geometry, degree of offset and or CCD angle. This is not the case for contemporary long stem devices which rely on a more diaphyseal region for anchorage and stability and therefore depend on stem variants and modularity to cater for morphology changes.
