Abstract
Crosby and Colleagues described 24 scapula fractures in 400 reverse shoulder arthroplasties and classified scapula fractures after reverse shoulder arthroplasty into 3 types.
Type 1 – true avulsion fracture of acromion related to a thinned out acromion (post-acromioplaty or cuff arthropathy). A small bone fragment dislodges during reduction of RSA.
Type 2 – Acromial fracture due to Acromio-clavicular (AC) joint arthrosis. They feel the lack of movement at the AC joint leads to stresses across the acromion and cause it to fracture. They recommend AC joint resection and ORIF of acromion, if the acromion is unstable.
Type 3 – true scapula spine fracture caused by the superior screw acting as a stress riser. This fracture occurs about 8 months after the arthroplasty and is a true stress fracture requiring open reduction and internal fixation.
Of 123 reverse shoulder arthroplasties performed from Jan 2003 to Feb 2011, a total of 6 scapula fractures were encountered post-surgery. Three were acromial fractures and three were scapula spine fractures all related to trauma. The fractures of the spine occurred between 6 months and 4 years post arthroplasty. We feel the fractures were traumatic but did occur through the posterior or superior screws from the metaglen. where stress risers developed for a fracture to occur.
We found that using a sliding osteotomy of the spine of the scapula to bridge the defect of the scapula and a double-plating technique using two plates at 90 degrees to each other provides a satisfactory outcome after 3–6 months where patients can start actively elevating again. This method of treatment will be presented.
