Abstract
Backgrounds
The rigid fixation of glenoid base plate is essential for the prevention of dissociation of the construct in the reverse total shoulder arthroplasty. For the rigid fixation, ideal placement of fixation screw is crucial but it is difficult to determine the best direction and length of screws. The purpose of this study was to determine configuration of optimal screw in cadaveric scapulae and compare with that in patient who underwent reverse total shoulder arthroplasty.
Materials and methods
Seven scapulae were used and implanted using a variable angle base plate with four directions screws. Optimal screw placement was defined as that which maximized screw length, accomplished far cortical purchase. Insertion angle and length of every screw was measured from AP and axial radiograph taken after the screws fixation. In a similar manner, the insertion angles of screws were measured from radiographs of 7 postoperative patients who underwent reverse total shoulder arthroplasty. The averages of length and insertion angle of 4 screws from two groups were compared.
Result
The average lengths of screws were anterior 29.4 mm, posterior 15.0 mm, superior 36.0 mm, inferior 46.7 mm in the cadavers group and 22.2 mm, 22.3 mm, 28.0 mm, 29.1 mm each in the patient group. There was statistical significance of the difference of the insertion angle of superior and inferior screws between two groups.
Conclusion
Trajectory angles of superior and inferior screw were smaller than those of optimal screws. Awareness of this tendency is helpful to insert the optimal screws intraoperatively.
