Abstract
Clinical success of total knee arthroplasty is correlated with correct orientation of the components. Controversy remains in the orthopaedic community as to whether the intramedullary or extramedullary tibial alignment guide is more accurate in the tibial cut.
Is there any difference between intramedullary and extramedullary jigs to achieve better accuracy of the tibial components in total knee replacements?
A retrospective study done on 100 patients during the time period 2007 to 2010. The 100 knee replacements were done by the same surgeon, where 50 patients had the intramedullary tibial alignment guide and the other 50 had the extramedullary one. The tibiofemoral angle was measured pre-operatively as well as post operatively, the tibial alignment angle was measured post operatively then the results were statistically analysed using the SPSS.
There was no significant difference between both groups regarding the tibial alignment angles. Both techniques proved accurate in producing an acceptable post operative tibial component alignment angle. We recommend orthopaedic surgeons choose either technique knowing that accuracy levels are similar.
The debate between intramedullary and extramedullary tibial cutting jigs/guides/ devices continues and most orthopaedic surgeons will use their preferred technique and will continue to achieve good post operative results as we have found in our centre. Our study is rare due to the fact we have a single surgeon performing both techniques, therefore controlling for any surgical experience or operating technique differences.
