Abstract
Introduction
Curved varus intertrochanteric osteotomy of the femur is an excellent and minimally invasive method for the treatment of osteonecrosis of the femoral head or osteoarthritis of the hip for joint preservation. However, the early postoperative complications of this procedure may be due to separation at the osteotomy site and an increase in varus angle due to early partial weight bearing.
Methods
We modified the curved varus intertrochanteric osteotomy of the femur by performing an additional rotation. Regarding the surgical technique, curved varus osteotomy is performed at an angle of 30 degrees to the femoral shaft and an additional rotational osteotomy is also performed at an angle of 15 or 20 degrees to the osteotomy plane. Partial weight bearing with one-third body weight is permitted 3 weeks after surgery.
Results
Curved varus intertrochanteric osteotomy of the femur was designed for developmental dysplastic hip by Nishio in 1969 and reported to have good outcomes in 1971. An important feature of this method is that the incidence of high riding of the greater trochanter or shortening of leg length is less than that in varus intertrochanteric osteotomy. Moreover, good contact at the osteotomy site and less lateral shift of the femoral shaft is observed. However, we have experienced a case of separation at the osteotomy site and increase of the varus angle in our hospital. Previous reports recommended that partial weight bearing with one-third body weight should be initiated after 5 weeks and full weight bearing after 6 months because the contact area is decreased at the osteotomy site by varus osteotomy. The post-operative recovery of the patients with total hip arthroplasty is rapid, therefore, we must consider important issues such as initiating the rehabilitation program early and reducing the duration of hospitalization. As per our experience, we think that partial weight bearing with one-third body weight should be initiated at 3 weeks. At the osteotomy site, we rotated the nearest bone segment to move it such that it intersects the proximal and distal bone cortex. Therefore, the osteotomy site will be stabilized and will have the ability to endure load. Another feature of this technique is that the partial removal of the necrotic area leads to an increase in the healthy load-bearing area. A limitation of this method is that an angle of an additional rotation is up to 30 degrees, because the joint capsule cannot be incised circumferentially and the short external rotator tendons should also be preserved.
Conclusion
Modified curved varus intertrochanteric osteotomy is a useful method for the prevention of increased degree of a varus angle as well as for obtaining more intact area of femoral head in osteonecrosis.
