Abstract
Abstract
Objectives
Impingement of total hip replacements (THRs) can cause rim damage of polyethylene liners, and lead to dislocation and/or mechanical failure of liner locking mechanisms[1]. A geometric model of a THR in situ was previously developed to predict impingement for different component orientations and joint motions of activities[2]. However, the consequence of any predicted impingement is unknown. This study aimed to develop an in-vitromethod to investigate the effects of different impingement scenarios.
Method
A ProSim electro-mechanical single-station hip simulator (Simulation Solutions) was used, and the 32mm diameter metal-on-polyethylene THRs (DePuy Synthes) were assessed. The THR was mounted in an inverted orientation, and the input (motion and loading) applied simulated a patient stooping over to pick an object from the floor[3]. The impingement severity was varied by continuing motion past the point of impingement by 2.5° or 5°, and compressive load applied in the medial-lateral direction was varied from 100N to 200N. Each test condition was applied for 40,000 cycles (n=3). Rim penetration was assessed using a CMM and component separation was measured during the tests.
Results
Varying the impingement severity from 2.5° to 5° increased rim penetration two-fold (by >0.05mm) and increased medial-lateral component separation three-fold (by >0.3mm) (both p<0.001). Increasing the medial-lateral load had less effect on the rim penetration and component separation, with exception of rim penetration with the higher impingement severity condition.
Conclusion
The impingement severity influenced the medial-lateral component separation, suggesting that increasing the impingement severity could increase the risk of dislocation. The impingement severity, which could be predicted from geometric modelling, was also found to significantly affect rim penetration, meaning this method could be used alongside geometric modelling to predict impingement severity in a range of scenarios.
Declaration of Interest
(a) fully declare any financial or other potential conflict of interest
