Abstract
When compared with traditional techniques, computer-assisted total knee arthroplasty (TKA) has been shown to allow more accurate coronal alignment of the implants with fewer “outliers.” Most navigation systems in computer-assisted TKA utilize rigidly-fixed trackers placed on both the femur and tibia, a computer workstation, and navigation software to determine the mechanical axis of the extremity intraoperatively, in real time. The purpose of this study was to report the initial experience of a single surgeon with a novel navigation system. This system utilizes a “pinless” technique using trackers that are mounted at the articular surface of the knee instead of being fixed to the femur and tibia.
Sixty-Six consecutive TKAs were performed using a novel “pinless” navigation system by a single surgeon. At 4 weeks post-operatively, coronal alignment was assessed with long-standing AP radiographs. The alignment measurements were then compared to historical controls.
The average alignment in the coronal plane was 1.73° +/−1.50° deviation from neutral alignment. Variance was 2.26°. The c onfidence interval constructed with an alpha value of.05 was (1.50°, 2.40°). Five knees had a coronal alignment greater than 3° from neutral. Of these five, three had an ipsilateral total hip replacement, and 2 were morbidly obese. There were no pin site infections nor pin site fractures. There was 1 late hematogenous infection.
This study reports an initial single-surgeon experience of a novel “pinless” navigation technique for TKA. The technique in this study is a novel and safe method to reconstruct a neutral mechanical axis, as it avoids the morbidity of the application of navigation tracking pins and therefore enhances patient safety.
Correspondence should be addressed to Diane Przepiorski at ISTA, PO Box 6564, Auburn, CA 95604, USA. Phone: +1 916-454-9884; Fax: +1 916-454-9882; E-mail: ista@pacbell.net
