Abstract
Prevention of surgical infection following joint arthroplasty is preferable to treatment.
Prevention requires identification and control of the potential sources of microbial contamination. The purpose of this study was to determine whether the density of airborne particulate in the operating room during total joint arthroplasty could predict the density of viable airborne bacteria at the surgery site.
A standard particle analyzer was used to measure the number and diameters of airborne particulate during 22 joint arthroplasty surgeries performed in non-laminer flow rooms. An impact air sampler and standard culture plates were used to collect airborne particulate and were analysed to identify and count colony-forming units.
Particulate density averaged > 500,000 particles/ft3, and 1,786 colony-forming units were identified, primarily gram-positive cocci. The density of particles ≥10um explained 41% of the variation in colony-forming unit density. Colony-forming units and ≥10 um particle density increased with longer surgery duration and higher staff counts.
This is the first study to the authors knowledge that shows a correlation between the number of persons in the OR and CFUs at the surgical site during total joint arthroplasty procedures. Increasing surgical staff appear to produce both more particulate and more CFUs. These observations support the use of environmental controls that isolate and protect the surgical site from airborne particulate and microbial contamination.
Continuous monitering of particulate larger than 10 um during joint arthroplasty procedures may be warrented.
Correspondence should be addressed to Diane Przepiorski at ISTA, PO Box 6564, Auburn, CA 95604, USA. Phone: +1 916-454-9884; Fax: +1 916-454-9882; E-mail: ista@pacbell.net
