LIMB LENGTH AND FEMORAL OFFSET RECONSTRUCTION DURING THA USING CT-FREE COMPUTER NAVIGATION

Abstract

Background: Leg length equality and femoral offset restoration are important parameters related to success of total hip arthroplasty (THA). However, it is not uncommon for errors to occur during surgery which can lead to less optimal functional result and potential source for litigation. Several techniques that are commonly used to assess leg length and femoral offset during THA include pre-operative templating, intra-operative measurements with a ruler using bony landmarks, assessing soft tissue tension and using measurement device with a reference pin in the iliac crest. We have previously reported on our precision to reconstruct the diseased hip with THA done without navigation. Post-operative radiographic analysis demonstrated that leg length was restored to within +/− 4mm of the contralateral side in only 60% of the patients with 4 patients needing a shoe lift. With regards to femoral offset reconstruction, it was increased by a mean of 5.1 mm and restored to within +/− 4mm of the normal contralateral side in only 25% of patients.

Computer navigation has proven to be a more precise tool to achieve optimal positioning of THA implants and precise biomechanical reconstruction of the hip joint. However, performing complete THA using navigation is complex including the requirement to change the position of the patient during registration. A recent stand-alone CT-free hip navigation software from Orthosoft Inc allows navigation to be used for limb length and offset measurements during THA. We report our results from a preliminary study using this technique in 14 hips undergoing THA.

In this technique, a tracker is placed over the iliac crest. There is no need to fix a tracker on the femur. Registration of the following are done: greater trochanter (using a screw), patella (using an ECG lead) and the plane of the operating table (using three points on the surface of the operating table in a triangular configuration). The centre of rotation of the hip is determined by either mapping the acetabulum or by using the appropriate sized calibrated reamer. With the definitive acetabular component in place, the new center of rotation is registered and the hip is reduced with trial femoral component. Re-registration of the new position of the greater trochanter and patella allows the computer to calculate the relative change in the limb length and offset compared to the pre-operative status. The differences in the pre-operative and post-operative limb length and offset were calculated using Imagika software and compared with the navigated values recorded by the computer.

The mean absolute error for the relative change in the limb length as measured by the computer when compared to the radiographic measurement was 1.25 mm with a standard deviation of 1.77 mm. The mean absolute error for the relative change in the offset as measured by the computer when compared with the radiographic measurement was 2.96 mm with a standard deviation of 2.56 mm. The process of navigation was quick and on average adds 10 minutes to the operative time.

Our preliminary study shows that the accuracy of the navigation software is very good in estimating the change in the limb length intra-operatively with a maximum error of 3 mm. The accuracy was also good in estimating the offset (3 mm or less except in one case where the error was 5 mm and this may be due to technical error in registration). This compares favorably with our own data on THA done without navigation. This easy to use navigation technique has the potential to decrease the magnitude of error in restoration of limb length and offset during THA.

We thank Francois Paradois and Michael Lanigan from Orthosoft Inc. for their technical advice.