Abstract
The long-term survival of total knee arthroplasty (TKA) has been well established; however, functional outcome remains inconsistent. More normal postoperative TKA kinematics have been shown to produce better knee function. Improved kinematics can be obtained by using implants with optimised surface geometry. Hence a TKA with an appropriate surface geometryis likely to provide superior long-term functional outcome. The Advance-Medial Pivot TKA (Wright Medical) is a fixed bearing prosthesis with a conforming medial compartment and a non-conforming (flat on flat) lateral compartment. This surface geometry is designed with the intention of replicating the normal knee motion of sliding or pivoting medially and rolling back laterally.
Aim: To investigate the sagittal plane kinematics of Advanced Medial Pivot Knee and compare with those of “flat on flat” fixed bearing TKA and normal knees
18 patients who had undergone primary TKA for osteoarthritis were recruited at an average of 18 months post operation. These patients performed flexion and extension exercises against gravity and a step up exercise. Video fluoroscopy of these activities was used to obtain the patellar tendon angle (PTA). This is a previously validated method for assessing sagittal plane kinematics of a knee joint. The kinematic profile of the Advance Medial Pivot Knee was compared to the profile of 14 normal knees and 30 flat on flat, fixed bearing TKA’s.
The sagittal plane kinematics of the Advance TKA differed from the normal knees. However, similarly to normal knees, a linear relationship was observed between PTA and knee flexion angle throughout knee flexion range. The kinematics of the Medial Pivot Knee were similar to normal when the knee was in a highly flexed position.
Functional plane kinematics of the Advance Medial Pivot TKA appear to meet the design criteria in that a linear relationship between PTA and flexion angle is maintained. Further work is required to establish if these improved sagittal plane kinematics translate into improved functional outcome.
Correspondence should be addressed to Richard Komistek, PhD, International Society for Technology in Arthroplasty, PO Box 6564, Auburn, CA 95604, USA. E-mail: ista@pacbell.net