Abstract
Femoral nails are thought to be load sharing devices. However, the specific load sharing characteristics and associated stress concentrations have not yet been reported in the literature. The purpose of this study was to use a validated, three dimensional finite element model of a nailed femur subjected to gait loads in order to determine the resulting stresses in the femur and the nail. The results showed that load was shared between the nail and the bone throughout the gait cycle. In addition, high stress concentrations were noted in the bone around the screw holes, and dynamization was of minimal benefit.
To determine the stresses in the bone and nail in a femur with a locked, retrograde, intramedullary nail.
The retrograde femoral nail is a load sharing device. High stress concentrations occur in the bone around locking screw holes. When only one locking screw is used proximally and distally, stresses in the implant are excessive and may lead to failure. Dynamization was of minimal benefit.
This is the first study to use a validated three dimensional finite element model to provide a detailed biomechanical analysis of stress patterns in a retrograde nailed femur under gait loads. The results can help resolve issues of stress shielding, implant removal, number of locking screws and dynamization.
In the fully locked condition, loads in the femur were significantly higher than those in the nail for most of the gait cycle. Removal of locking screws to obtain dynamization only increased axial load in the femur by 17 %. However, stresses in the locking screws increased by as much as 250% when fewer than 4 screws were used. Maximum stresses in the bone were found around screw holes.
A three dimensional finite element model of the femur and nail was developed. The model was validated by comparing results to a physical saw bone model instrumented with strain gages and subjected to a simple a compressive load. Once good correlation with simple loading patterns was demonstrated, gait loading patterns obtained from literature were incorporated and simulations were run for various conditions.
Correspondence should be addressed to Cynthia Vezina, Communications Manager, COA, 4150-360 Ste. Catherine St. West, Westmount, QC H3Z 2Y5, Canada
