STRESSES AT THE END OF A DISTAL FEMORAL PLATE: IMPLICATIONS FOR REFRACTURE

Abstract

A novel, validated three dimensional finite element model of the femur was used to characterize the stress concentration in the bone at the proximal end of a fracture fixation plate. A supracondylar fracture of the distal femur fixed with a plate was modeled utilizing physiologic load patterns simulating several phases of a cycle of gait. The relative maginitude and length of the zone of increased stress was characterized. The effects of varying plate geometry and material in the attempt to decrease stress concentration at the end of the plated were investigated.

The exact nature and distribution of stresses around femoral fracture fixation plates remains unclear making it difficult to determine how close to existing hardware a distal femoral plate can be implanted. Our objective was to use a novel, validated finite element (FE) model to examine the stress distribution at the proximal end of the plate.

The von Mises element stresses in the bone without the implant were compared to those with the implant. Additionally, we determined the effect of metal (titanium versus stainless steel), and plate taper (ten, thirty and forty-five degrees) on stresses at the proximal end of the plate.

The peak von Mises stress in the plated bone occurred below the corners of the plate, and was approximately four times that in the un-plated case (thirty-eight MPa versus nine MPa). We identified a distance of 34 mm (approximately one bone diameter) beyond the edge of the plate before stresses returned to within 1% of the un-plated control. The choice of metal did not affect the state of stress distribution in the bone beyond the proximal edge of the plate. In addition, the stress concentrations decreased proportionally as the taper angle decreased from forty-five to ten.

Utilizing this FE model we report the following:

1. Stresses are concentrated at the end of plates and return to within normal limits approximately one bone diameter beyond the edge of the plate.

2. The stress concentrations decrease proportionally as the taper angle decreases.

3. Titanium plates offer no added advantage in stress reduction at the end of the plate.

Funding: The authors gratefully acknowledge the financial support of Materials and Manufacturing Ontario (MMO) and the Dean’s New Faculty Seed Grant at Ryerson University.