SEQUENTIAL VERSUS SIMULTANEOUS CEMENTING OF COMPONENTS IN TOTAL KNEE REPLACEMENT: A PROSPECTIVE RANDOMISED STUDY USING COMPUTER NAVIGATION

Abstract

Aim: The study was conducted to evaluate differences between simultaneous and sequential cementing of the tibial and femoral components in total knee joint replacement in relation to final component alignment. Our hypothesis was that cementing the components sequentially increases accuracy of the final position.

Method: This was a prospective and randomised study, performed using a computer navigation system as the evaluation technique to determine the accuracy of implant positioning. All knee replacements (Scorpio, Stryker) were implanted with the assistance of computer navigation. The patients were divided into two groups of 20 patients each. The first group had implants cemented simultaneously where the tibial and femoral components were implanted with a single mix of cement and then pressurized by extending the leg. The second group of patients had the tibial component inserted with the first mix of cement and then impacted. Then the femoral component was inserted using a second mix of cement. Computer navigation was used to measure varus/ valgus cut of the femur, varus/ valgus cut of the tibia, and sagital slope of the tibia. Measurements were made with the components in place, both before cementing and then after cement cure.

Results: Our results show a statistically significant improvement in accuracy of femoral varus/ valgus alignment using the sequential cementing technique.