Abstract
Background Context: Total disc replacement (TDR) gained enormous popularity as a treatment option for symptomatic degenerative disc disease in the last few years. But the impact of the prosthesis design on the segmental biomechanics in most instances still remains unclear. As TDR results in a distraction of the capsuloligamentous structures, the disc height seems to be of crucial importance for the further biomechanical function of the operated level. Yet the biomechanical role of disc height after TDR still remains unclear.
Purpose: The purpose of study was to evaluate the influence of prosthesis height after total disc replacement on: 1) the sagittal balance and 2) the range of motion.
Study design: A radiological and an in-vitro biomechanical study.
Method: 6 human, lumbar spines L4–L5 were tested in vitro.The segmental lordosis of the specimen were measured on plain radiographs and the range of motion was measured for all six degrees of freedom with a previously described spine tester. The segmental lordosis and the range of motion at level L4–L5 was evaluated for following settings: 1) intact state 2) after implantation of a prosthesis with 5mm endplate 3) after implantation of a prosthesis with 7mm endplate.
The prosthesis used was a prototyp and had a constrained design with a ball and socket principle.
Results: Even the implantation of the lowest possible prosthesis height (5mm endplate) resulted in an increase of segmental lordosis (intact: 6.9; 5mm endplate: 8.8; p=0,027). Using a higher prosthesis (7mm endplate) further increased the segmental lordosis (10.5, p=0.041). The implantation of the lowest prosthesis resulted in significant increase of movement capability compared to the intact status for flexion-extension (8.6 vs 11.4; p=0.046) and axial rotation (2.9 vs 5.1; p=0.028). Lateral bending did not changed significantly (9.4 vs 8.6; p=0.345). The implantation of the higher prosthesis (7mm endplate) resulted in similar movement capability compared to intact status for flexion-extension (8.4 vs 8.6; p=0.116) and axial rotation (3.3 vs 2.9; p=0.600). Lateral bending decreased significantly compared to the intact status (5.1 vs 8.6; p=0.028).
Conclusion: Total disc replacement with the lowest prosthesis height inherently increases segmental lordosis. Further increase of disc height results in a significant enhancement of segmental lordosis by decreasing the range of motion for all three degrees of freedom. Yet, methods for scheduling the ideal disc height preoperatively, to provide a physiological lordosis thereby maintaining physiological range of motion postoperatively, seems not to be established already.
Theses abstracts were prepared by Professor Roger Lemaire. Correspondence should be addressed to EFORT Central Office, Freihofstrasse 22, CH-8700 Küsnacht, Switzerland.
