Abstract
Background: The Profix Total Knee Arthroplasty (Smith and Nephew, Memphis, USA) is designed to replace less bone than is resected from the posterior femoral condyles, and as a consequence the posterior condylar offset is reduced. The net effect of this is to increase the flexion gap with no effect on the extension gap. This is a deliberate design philosophy aimed at increasing postoperative flexion. This prospective cohort study has tested this theory.
Methods: 60 patients underwent primary posterior cruciate retaining (CR) TKA using this prosthesis. A matched group of patients, employing a different CR prosthesis which replaces excised bone in full, served as historical controls. Intra-operative measurements were made of the posterior condylar bone resected in each case. These measurements were then correlated with the flexion achieved both intra-operatively and at 6 months post-operatively.
Results: A positive correlation between pre-operative and post-operative flexion was found. However, there was no correlation between the relative increase in flexion gap secondary to the reduction in posterior offset and the resulting flexion range.
Conclusion: Post-operative flexion range is not increased by the resection of more bone from the posterior femoral condyles than is replaced by the prosthesis in TKA. The loss of bone stock will have implications for revision surgery and should be avoided.
Theses abstracts were prepared by Professor Roger Lemaire. Correspondence should be addressed to EFORT Central Office, Freihofstrasse 22, CH-8700 Küsnacht, Switzerland.
