Abstract
Introduction A new technique of ankle syndesmosis fixation is proposed. Buttons are placed on both sides of the ankle, connected by a strong non-absorbable suture. The technique is simple and minimally invasive: a medial incision is not required. It resists diastasis whilst allowing physiological micromotion and does not require routine removal.
Methods The technique was tested on a cadaver model of a Maisonneuve injury under increasing torque loads. Sixteen embalmed cadaver legs were randomised to receive suture-button fixation or four-cortical 4.5 mm syndesmosis screw fixation. A prospective clinical study involving 16 patients with Weber C fractures and syndesmosis diastasis is presented. They underwent suture-button fixation and the results were compared to 16 consecutive patients with syndesmosis screw fixation.
Results In the cadaver study, both groups had similar rates of diastasis following torque loading. However, the suture-button did give a more consistent performance: standard deviations were significantly lower (p=0.001) than the screw group. In the clinical study, both groups were evenly matched as regards patient age, male: female ratio, and fracture patterns. Mean AOFAS ankle outcome scores at three months were significantly better in the suture-button group (91 versus 82, p=0.01). No suture-button patients required implant removal. They had a faster return to work compared to the screw group (three months versus five months). Axial CT scanning performed at three months post-op showed all implants to be intact with no loss of reduction.
Conclusions Suture-button syndesmosis fixation is simple, safe, effective and physiological. It has shown improved outcomes and faster rehabilitation, without needing routine removal. It may become the treatment of choice in Weber C ankle fractures with a syndesmosis diastasis.
In relation to the conduct of this study, one or more the authors have received, or are likely to receive direct material benefits.
The abstracts were prepared by Mr Jerzy Sikorski. Correspondence should be addressed to him at the Australian Orthopaedic Association, Ground Floor, William Bland Centre, 229 Macquarie Street, Sydney NSW 2000, Australia.
