STUDY OF LOCKING IN REVISION FEMORAL IMPLANTS

Abstract

Purpose: We performed mechanical trials to quantify the contribution of locking to the stability of revision femoral implants. The implant tested was a revision prosthesis with anatomic metaphyseal contact locked with three distal bolts measuring 4.5 mm.

Material and methods: Twelve implants were impacted into composite saw bones with constant and known dimensions and mechanical properties. Three displacement sensors were used to measure micromovements between the prosthesis and the bone: three specially designed force sensors were inserted into the bolt holes to measure the force distributions for each hole. Measurements were made with an Instron. Compression cycles (780 1-Hz cycles, 100daN applied to the femoral head) and torsion cycles (780 1-Hz cycles, 4.5 Nm applied to the femoral head) were used to simulate loading and weight-bearing and to estimate the evolution of the system. Trials were conducted in two different configurations: stable metaphyseal prosthesis, unstable metaphyseal prosthesis (simulating surgical resection). These two configurations were tested with a locked and with a non-locked implant.

Results: Loading distribution between the bolts was variable and depended on the insertion conditions, implant/bolt tolerance, and the quality of the supporting bone. In the “stable” metaphyseal configuration, the bolts carried a large percentage of the compression force (up to 30%) despite the support provided by the metaphysis; when exposed to torsion stress, the metaphyseal form of the prosthesis carried the charge and avoided this phenomenon. Locking had only minimal effect on micromovements, the impaction and the form of the prosthesis maintaining its stability. For the “unstable” configuration, locking created a stable situation: micromovements were limited to those observed in the stable prosthesis (< 150 μm), compatible with bone regrowth. The bolts carried most of the charge (74.8 ±20%; 56.0±41.7%) during the compression and torsion tests. Loading created major stress within the bolts whose properties (strict diameter 4.5 mm, lateral threading) should be taken into consideration to avoid risk of rupture beyond the elastic limit of the material.

Discussion: These results can be reasonably extrapolated to surgical situations leading to the following conclusions: locking is useful and reliable after surgical resection, all the holes available should be used for locking, “rational” unlocking can be useful if “physiological” metaphyseal stress is desired.