Neck modularity has been proposed to improve THA accuracy, thanks to the close restoration of anatomy, however it has been associated with issues like early breakages or corrosion. Our Hospital has been using neck modularity since the 90s, so we analyzed retrospectively implants performed between January 2000 and December 2014. The minimum follow up was 1Y. The cohort was composed of 1,033 THAs or 951 patients (82 bilateral), of which 643 females and 390 males. Average patient age was 67.7Y. THA indications were primary Osteoarthritis (80.9%), Fracture (9.0%), Congenital Dysplasia or Congenital Luxation (4.2%), Osteonecrosis (3.2%), other causes (2,7%). The stems used were all cementless, 381 anatomically shaped (36.9%), 635 straight (61.5%), 17 short MIS (1.6%). All necks used were made of Titanium alloy. 419 implants (40.5%) were manufactured by Wright Medical, while 614 (59.5%) were produced by Adler Ortho. A total of 37 revisions has been reported, mainly due to periprosthetic fractures (32.4%), luxation (24.3%), implant mobilization (18.9%) and implant breakage (16.2%). We have recorded 3 modular neck breakages. 4 patients required re-revisions, because of luxations (3) and neck breakage (1). The overall survival rate was 96.4%. We did not observe any component corrosion, probably thanks to the exclusive use of Titanium necks. We had a neck breakages rate of 0.29% and a luxation rate of 0.87%, lower than normally reported in the literature. In conclusion, our experience suggests as neck modularity could be a safe and effective way to reconstruct the proximal femur in THA patients.

Summary Statement

In a retrospective study, FE-based bone strength from CT data showed a greater ability than aBMD to discriminate proximal femur fractures versus controls.

Undisplaced or minimal displaced medial neck femoral fractures are treated with canulated screws either in young or in elderly patients with good functional capacity, without severe comorbidity and cognitive impairment. We also perform this procedure in patients with very low daily activities and affected by severe comorbidity, with the aim to reduce pain. We reserve total hip replacement in middle-advanced age, with good level of functional activity and adequate bone-stock. We use bipolar hemiarthroplasty in patients that need early mobilization for the presence of comorbidities that could worsen. We prefer cemented bipolar hemiarthroplasty, as it gives an optimal primary stability, without press-fit. We prefer to utilize bipolar hemiarthroplasty with memory shape stem F.G.L. (Fig.1) in high risk patients (ASA classification). In fact the use of cement prolongs duration of surgery and is associated with higher perioperative mortality from cardiopulmonary complications. This stem in its metaphyseal region has 10 tabs, made of a Nitinol alloy (Ni-Ti). The feature of this alloy is to enlarge when brought to a certain temperature. When F.G.L. stem is mantained at 4° - 7° C the Nitinol (r) tabs are in the “restrained” configuration. Just at the time of surgery procedure, the stem is taken out of the refrigerator and inserted into the femoral diaphysis. At corporeal temperature, the Nitinol tabs enlarge, compressing the metaphyseal cancellous femoral region and give an immediate primary stability. We report clinical and radiological results of 15 patients (mean follow-up: 8 months) that underwent surgical procedure of bipolar hemiarthroplasty with F.G.L. stem in our department from March 2008 to December 2009. We had no perioperative complications and the results overlapped those of patients that underwent standard cemented bipolar hemiarthroplasty. The advantage of the use of F.G.L. stem is that it allows an immediate primary stability without searching an extreme press-fit. The disadvantage is the higher cost respect a standard cemented bipolar hemiarthroplasty. Therefore its use should be limited to those patients in which the surgery time must be contained for severe comorbidity, or in patients in which specific cardio-pulmonary complaints make dangerous the use of cement.

Introduction: The main goal of surgical correction of hallux valgus is the morphological and functional rebalance of the first ray and correcting all the characteristics of the deformity. Historically, distal metatarsal osteotomies and SCARF have been indicated in cases of mild or moderate deformity with inter-metatarsal angles up to 20° and are procedures widely used for correction of hallux valgus. The aim of this study is to compare a distal metatarsal osteotomy recently described (SERI) with SCARF osteotomy in a clinical prospective randomised study.

Methods: 20 patients with bilateral hallux valgus similar on both sides regarding clinical and radiographic assessment were included. Clinical evaluation using American Orthopaedic Foot and Ankle Score (AOFAS) and radiographic assessment were considered before surgery up to 2 years follow-up. All patients were operated bilaterally in the same surgical sitting, and received at random SCARF osteotomy on one side, and on the other a SERI osteotomy performed through a 1 cm skin incision under tdirect view control and fixed with one Kirschner wire. Duration of surgery was recorded. Postoperative care was similar in both groups and consisted of gauze bandage and weight bearing with talus shoes for 30 days.

Results: No statistical differences were observed in preoperative HVA, IMA, DMAA in both groups. Average surgical time was 17 minutes in SCARF and 3 minutes in SERI (p< 0.0005). No complications were observed in the series, with no wound dehiscence. All osteotomies healed uneventfully. At 2 year follow up, no statistical differences were observed in HVA, IMA, DMAA comparing SCARF with SERI. Average AOFAS score was 87±12 in SCARF and 89±10 in SERI (p=0.07).

Conclusions: Both SCARF and SERI techniques proved effective in the correction of hallux valgus, however SERI, performed with a shorter skin incision, in less surgical time, fixed with a cheaper device (one Kirschner wire), resulted in a better clinical outcome.

Introduction: Facioscapulohumeral muscular dystrophy (FSHD) is the third most common hereditary disease of the muscle after Duchenne and myotonic dystrophy. FSHD consists in an atrophic myopathy with predominant involvement of the face, upper arms, and shoulder muscles. FSHD compromises the muscles of the scapu-lothoracic joint, and usually spares muscles of the scapu-lohumeral joint. Consequently, when the patient tries to abduct or foreword flex the shoulder, the contraction of the relatively preserved scapulo-humeral muscles produces an abnormal rotation of the scapula, that is not hold to the chest wall because of the insufficiency of the scapulo-thoracic muscles, resulting in a winged scapula and in a limited arm motion. The aim of this study is to describe an original scapulopexy and report the long term results obtained in 9 patients affected by FSHD.

Material and methods: Nine patients (4 male and 5 female) affected by winged scapula in FSHD were observed and selected. Average age at surgery was 25 years (range 13–39). Surgery consisted in scapulopexy of both sides in the same surgical time. Through a skin incision on its medial border the scapula was exposed and positioned over the chest. The 5th to the 8th ribs were exposed in the part below the scapula. The position of the scapula over the chest was fixed by 4 doubled metal wires to the 5th, 6th, 7th and 8th rib. Each wire was passed anteriorly to the rib, and into a hole performed 1.5 cm from the medial border of the scapula. By tightening the wires, the scapula was fixed firmly over the chest. A figure of eight dressing that holds the shoulders back was applied immediately after surgery and maintained for six weeks.

Results: The average surgical time was 65 minute for each single procedure. One patient experienced an unilateral pneumothorax the day after operation, which resolved spontaneously in 48 hours. Average follow up was 11 years (range 3–15). All patients experienced a complete resolution of the winged scapula and an improvement of range of motion of the shoulder compared to the pre operative conditions. Average pre-operative abduction was 68 and post-operative was 85. Average pre-operative flexion was 78 and post-operative 112.

Discussion: This technique is easy and quick to perform, does not require grafts, reduces post surgical complications such as pneumothorax or haemothorax, and ensures good results even at considerable follow-up.

Introduction: Neck hyperextension (NH) is defined as a progressive increase of lordosis associated with a limitation in flexion of the cervical spine, which ultimately results in an inability to approximate the chin to the sternum. NH may occur in relation to several myopathies. It is characterized by a general weakness and contractures of the axial muscles which produces a progressive increase of lordosis associated with a limitation in flexion of the cervical spine, that forces the patient to assume awkward compensatory postures to maintain balance and level vision. This study reports on operative complications, the degree of correction, the achievement of a solid arthrodesis, the maintenance of the correction and the clinical assessment of 7 patients.

Material and methods: Seven patients affected by various myophaties and NH were included. The mean age was 16.5 years (10–28 years). All underwent surgery, in which the paravertebral muscles were detached from the spinous processes and then transversally sectioned in order to bilaterally expose the laminas of vertebrae C2 to C7. The space between C1–C2 appeared mobile, while the spinous processes from C2 to C7 were close together and thus allowed only a very limited motion in between them. Ligamenti interspinosus and nuchae were detached and the facet joints from C2 to C7 were enlarged by capsulotomy. With a spreader rongeur, the interspinous spaces at each level were gently opened. Cortical cancellous autologue graft were shaped into wedges. After careful opening of each interspinous space, the bone wedges were driven between the spinous processes to maintain the achieved correction. The average follow-up time was 10.4 years (2.4–16.5 years).

Results: No major surgical complications occurred. At follow-up, the average angle between C2–C7 in neutral position had decreased (p = 0.016) from 50.7 (40–70) to 21.4 (2–50). The range of motion in the C1–C2 joint remained unaffected, while it decreased in C2–C7 (p = 0.016) from 33.5 (15–64) to 1.8 (0–8). In all cases, a solid arthrodesis was achieved.

Discussion and conclusion: The follow-up showed significant clinical improvement of posture in all patients. Our study has shown surgical treatment of NH to be an effective method within the whole series of seven patients, achieving both good immediate and good long-term results.

Aims: The purpose of this paper is to review a series of ankle post-traumatic deformities treated by arthroplasty, þbula lengthening, bone graft and correction of the malunion. Methods: 30 cases, mean age 40 (±15), were operated 6–30 months after injury and followed up at 5 years. Clinical Maryland foot score (MFS) and X-ray evaluation were performed pre op and at follow up. After medial revision of bone and soft tissue structures, through a lateral transmalleolar approach, mal-union of the posterior malleolus or sinking of the lateral tibial plafond were corrected using autologous cortical cancellous bone graft covered by its periosteal ßap. Postoperative treatment consisted of immediate continual passive motion weightbearing allowed after an average of 8–12 weeks after surgery. Results: Pre op MFS was 64±8 and post-op it was 82±11. 11 patients had excellent results with normal range of motion, no pain, and no progression of the arthritis. The result in 9 cases was good with a normal range of motion, little pain after long walk, and no progression of arthritis. 7 cases were fair because of a decrease in the range of motion and progression of arthritis and moderate pain. 3 poor cases needed arthrodesis. Conclusions: Fibula lengthening, bone graft and correction of malunion were effective treatment of ankle post-traumatic valgus deformity in order to delay ankle fusion in young patients. The success of the procedure was correlated to the severity of arthritis and the joint congruity obtained by surgery.

Aims: The purpouse of the study is to review a series of hallux valgus treated by minimally invasive distal metatarsal osteotomy with a simple, effective, rapid, inexpensive (SERI) technique. Methods: 54 consecutive feet in 37 patients, aged 48 ± 23 years affected by hallux valgus deformity less than 40û with an intermetatarsal angle up to 20û were reviewed at 5 years follow up. Surgical technique consisted of a 1 cm medial incision at the metatarsal neck, then an osteotomy was performed using an oscillating saw. With a direct line of vision, all characteristics of the deformity (HVA, IMA, DMAA) were corrected by lateral displacement of the metatarsal head; contemporary plantar or dorsal displacement was performed according to insufþciency or overloading of the þrst ray. The osteotomy was stabilized by a 2 mm Kirschner wire. All patients were clinically (AOFAS score) and radiographically checked at an average follow up of 5 years. Results: The clinical score at follow up was (91±12). The pre-op hallux valgus angle was 32.5±9, while post-op it was 22±7 (p< 0.0001), pre-op inter-metatarsal angle was 13±3, while post op it was 9±3 (p< 0.0001), the pre-op distal metatarsal articular angle was 19±10, while post-op it was 9±7 (p< 0.0001). Conclusions: Clinical and radiographic þndings showed that SERI osteotomy permitted an adequate correction of all the pathologic characteristics of the deformity, and this factor is responsible for our satisfactory results.