V-Y PLASTY OF FLEXOR TENDON PULLEYS, A SIMPLE SOLUTION TO AN OFTEN DIFFICULT PROBLEM

Abstract

Introduction Zone 2 flexor tendon repairs can require ‘venting’ or partial resection of the A2 and/or A4 pulleys. We test a new technique where the pulley is divided and repaired with a V-Y plasty, increasing the pulley circumference. This allows access to perform the repair and/or permits free tendon gliding post-repair.

Methods Two groups of A2 and A4 pulleys from cadaveric fingers were divided and repaired in a V-Y fashion such that the circumference of the pulley tunnel was increased. The fingers were then mounted onto custom-made jigs and tested using a materials testing machine. One group had the A2 pulley assessed for changes in work of flexion by testing both before and after V-Y plasty. The second group had both the A2 and A4 pulleys tested for load to failure during functional loading. Biomechanical testing was performed.

Results There was a significant reduction in work of flexion after V-Y pulley expansion procedures were performed. Loads to failure for the A2 and A4 pulleys were in excess of 400% and 200% greater than one would expect in-vivo during a post-operative active mobilisation protocol. V-Y tendon pulley expansion increases the tunnel size while providing a mechanically sound pulley. It also maintains the pulley length and its coverage of the underlying tendon.

Conclusions This technique provides surgeons with an attractive alternative to simply ‘venting’ or resecting an otherwise troublesome pulley.