Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

O2312 THE INFLUENCE OF BONE DENSITY ON THE FIXATION STRENGTH OF BICONDYLAR TIBIAL PLATEAU FRACTURES – AN IN VITRO MECHANICAL STUDY



Abstract

Objective: To assess the inßuence of bone density on the þxation strength of bicondylar tibial plateau fractures. Method: Sixteen cadaver tibias were randomised into two groups to receive either dual plating or ring external þxation to stabilise a bicondylar tibial plateau fracture created with a standard method. The randomisation was stratiþed by BMD measured by DXA (above and below the mean). Cyclic axial compression tests were performed with increasing peak loads. Inter-fragmentary shear displacements were measured using four extensometers. Failure was deþned as over 3mm displacement. Results: There was a strong correlation between failure load and BMD [r=0.81, P< 0.001]. The mean failure load of the low BMD group (2701 N) was signiþcantly less than that with the high BMD (4530 N) [t-test=0.003]. The failure loads of the two þxation groups were not signiþcantly different (3520 N for the dual plating and 3710 N for the external þxation) [t-test=0.78]. BMD had a signiþcant effect on the failure load in the dual plating group [t-test=0.03], but not in the external þxation group [t-test=0.1]. Discussion: Failure of þxation has been reported as a common complication of bicondylar tibial plateau fractures with a rate as high as 30%. Osteoporosis and poor bone quality are considered important contributory factors. In our study this inßuence was evident with plating, but not with ring þxation. Ring þxation may be the preferred method of þxation for tibial plateau fractures in the elderly and osteoporotic patients.

Theses abstracts were prepared by Professor Dr. Frantz Langlais. Correspondence should be addressed to him at EFORT Central Office, Freihofstrasse 22, CH-8700 Küsnacht, Switzerland.