Abstract
Arthroscopic acromioplasty is said to be a difficult procedure to learn although Gartsman stated that most surgeons can reliably perform an arthroscopic decompression after instruction in 10–20 cases. We assessed the learning curve for one consultant surgeon.Patients were selected on the basis of clinical examination and all had signs of impingement at arthroscopy. Surgery was performed between February 1993 and June 1996. Patients with full thickness tears were excluded from the study. The senior author had not performed any arthroscopic acromioplasties prior to providing a service in this hospital. Each shoulder was assessed immediately prior to surgery and at follow up using the Constant and Murley method of functional assessment without the power component. Patients were asked if they would have the operation again, with the benefit of hindsight.Of 89 shoulders complete preoperative and postoperative scoring beyond 6 months was available in 71. Of these, 62 operations were performed by one consultant (ANS) and 9 by trainees under his guidance. Patient questionnaires were completed for 73 of 89 shoulders.
A standard operative technique under general anaesthesia was used for all patients.
The overall improvement in shoulder function was 10.3 (SD 12.4) points (p< 0.0001). The change in shoulder score did not vary with increasing surgical experience. The length of operation, however, shortened with increasing experience with a mean of 106 minutes and 60 minutes for the first and last five operations. Questionnaire analysis found 82% would have the operation again.
In our study operative time reached a plateau after approximately the first twenty five cases but the results of these early operations are good.
The abstracts were prepared by Mr Simon Donell. Correspondence should be addressed to him at the Department of Orthopaedics, Norfolk & Norwich Hospital, Level 4, Centre Block, Colney Lane, Norwich NR4 7UY, United Kingdom.
